Fisher & Paykel OR24SDMBGX Installation Instructions Manual page 8

i I i
+
+ 5/16"
Fig. 1.6
Supplied with the range
in a separate kit
Fig. l.7aj
LEVELLING THE RANGE
The range is equipped with 4 LEVELLING FEET (SUPPLIED IN A SEPARATE KIT) and
may be levelled by screwing or unscrewing the feet with a spanner (fig. 1.8).
It is important to observe the directions of figures 1.6, 1.7a, 1.7b.
Supplied with the range
in a separate kit
+ 5/16"
i
+20mm
_.+25/32"
Fig. 1.8
YOU MUST USE STABILITY
ANTI TIP BRACKET TO
PREVENT UNIT FROM
TIPPING.
ANTI-TIP STABILITY DEVICE INSTALLATION INSTRUCTIONS
1. The anti-tip bracket has to be attached as shown on figure below (only rear right
side), it has to be fixed on the floor and on the rear wall by no. 4 (four) suitable screws
(not supplied).
2. After fixing the anti-tip bracket, slide range into place. Be sure the rear right foot
slides under the anti-tip bracket attached.
Dotted line showing the position
of the range when installed
Fig. 1.9
ANTI-TIP STABILITY
DEVICE FIXING
\ " Anti-tip stability
device
Rear right
feet of rang{