Fisher & Paykel OR24SDMBGX Installation Instructions Manual page 14

INJECTORS TABLE
NOMINAL
POWER
BURNERS BTU/hr
Auxiliary (AUX) 3500
Semirapid (SR) 6000
Triple ring (TC) 12000
Oven burner 13000
Broil burner 8500
REDUCED LP/PROPANE NATURAL GAS
POWER 11"W.C.R 4"W.C.P.
BTU/hr 0 injector By-pass 0 injector By-pass
[1/100mm] [1/100 mm] [1/100mm] [1/100 mm]
1000 55 27 90 adjustable
1500 72 32 118 adjustable
5000 102 65 170 adjustable
1500 109 34 180 adjustable
88 146
Fig.2.8
OPERATIONS TO BE PERFORMED WHEN SUBSTITUTING
THE INJECTORS
,/ Remove the gratings, the burner covers and the knobs;
,/ Using a wrench substitute the nozzle injectors "J" (figs. 2.7 - 2.8) with those most
suitable for the kind of gas for which it is to be used.
The burner are conceived in such a way so as not to require the regulation of the
primary air.
Fig. 2.9
SETTING THE BURNER MINIMUM
When switching from one type of gas to another, the minimum flow rate must also be
correct: the flame should not go out even when passing suddenly from maximum to
minimum flame.
To regulate the flame follow the instructions below:
- Light the burner
- Set the gas valve to LO position
- Remove the knob
- With a thin screwdriver pass by the hole of microswitch and turn the screw F until
adjustment is correct (fig. 2.9).
For LP/PROPANE gas, tighten the adjustment screws completely.
14