Advertisement
3. Inserl lop and bottom Iegs of window filIer panel frame
into channel in the to angle and bottom rail. Do both
sides.
4. Insert washer head locking screws (2) into holes in
top leg of filler panel frame (see Step 6). Do not tolally
tighten. Allow leg to slide fi'cely. :;crows will be
tightened after Section 6.
Place
Cabinet
in
Window
I. Open x_indow and mark
center of windo_
stool.
2. Place cabinet in window with bottom stool angle firmly
scated over window stool as shown. Bring window
do_l
tcmpomrily behind top angle k) hold cabinet in
place.
STOOL
3. Shift cabinet left or right as needed lo line up cenler of
cabineI on center line marked on sIool.
4. Faslen cabinel to window stool wifll 2 screws into
holcs.(You may wish to pre-drilI pilot holes.)
5. Add bottom rail seal over screws to v_indow stool.
t-
Bottom
Rail Seal
m
o -,N
//°
|nstaR
Support
Bracket
I. Hold each support bracket flush against outside &sill,
and tight to bollom of cabinet as shown below. Mark
brackets al top level of sill, and remo_ e.
LEFI
(_
/2" LONG S(REWS
SILL ANGLE
f
FLA'I HEAl) BOL'I
2 EACH REQ'D FOR EACIq
SUPPOR'I BIL_.( KE']
2. Assemble sill angle bracket to support brackets at the
marked posilion, as shown, lland tighten, but allow
for an 3 changes later.
3. Install support brackets (with sill angle brackets
almched) to correct hole in bonom of cabinet as shown.
4. Tighten all 6 bolts securely.
/2"
{ong screws
al_d
locknuts
4
Advertisement
