Advertisement
Window
Mounting
H
Remove
Chassis
1. Pull down front panel and remove filter. (See F[G. 1).
2. Lift front upwards and place to one side.
_
install
Top Angle
and Side Bracket
1. Attach lbam gasket to top angle above holes as
shown in FIG. 6.
3. Locate the four front screws and remove. These screws will
be needed to re-install the front later. (See FIG.2)
4. Pry away fi-ont from cabinet sides as per photo (see NG.3)
5. Gently lift front offunit and place to one side (See FIG.4).
i/
6. Remove shipping screws
from top of unit and also on the side
by the base if installed. (See FIG.9)
7. Hold the cabinet while pulling on the base handle, and care-
fully remove the unit. (See FIG.2)
8. Add two lbam inserts to holes in top of cabinet where
shipping screws were removed from.
2. Install top
angle and
side retainers
to cabinet as
shown in FIG. 6.
FIG. 6
Assemble
Window
H
FRier Panels
1. Place cabinet on floor, a bench, or a table.
2. Slide "I" section of window filler panel into side retainer
on the side of the cabinet (see Figures 7-8). Do both
sides.
FIG. 7
PLASTtC
VqlN DOW FILLER
FILA_ME
PANEI
FIG.9
FIG. 10
9. Your umt may come with internal packaging_TIllS
PACKAGING MUST BE REMOVED PRIOR TO
INSTAl,LING THE AIR CONDITIONF_
BACK
1NTO THE CABINET. (See FIG. 5).
SIDE
REIAINER
FIG. 8
..........................................
Xii_i)_;Sf[:igiq_
TOP
( ABINET
PLA srrlc
FRAME
"
(N
I SECTI)
_,_N
v,
LDO
'
IIOLE
]qLLER
PAN
L
3
Advertisement
