Replacing The Battery - Ford 2014 EXPLORER Owner's Manual

Ford explorer

Hide thumbs Also See for 2014 EXPLORER:

Table of Contents

Keys and Remote Control

Replacing the Battery

Note: Refer to local regulations when disposing of transmitter batteries.

Note: Do not wipe off any grease on the battery terminals or on the

back surface of the circuit board.

Note: Replacing the battery will not delete the transmitter from your

vehicle. The transmitter should operate normally.

The remote control uses one coin-type three-volt lithium battery CR2032

or equivalent.

Integrated Keyhead Transmitter

4. Insert the new battery. Refer to the instructions inside the integrated

keyhead transmitter for the correct orientation of the battery. Press the

battery down to ensure that the battery is fully seated in the battery

housing cavity.

5. Reinstall the rubber gasket.

6. Snap the battery cover back onto the key.

2014 Explorer (exp)

Owners Guide gf, 1st Printing, April 2013

Note: Your vehicle's back-up keys

came with a security tag that

provides important key cut

information. Keep the tag in a safe

place for future reference.

1. Twist a thin coin in the slot near the key

ring to remove the battery cover (1).

2. Carefully peel up the rubber gasket (2)

from the transmitter if it does not come off

with the battery cover.

3. Remove the old battery (3).