Fisher & Paykel DS603SS Installation Instructions Manual page 8

._ INSTALLATION INSTRUCTIONS
STEP3:
ADJUSTING THEFEET(DOUBLE MODELSONLY)
DishDrawe¢
DOUBLE MODELS ONLY
Adjust the height of the product to suit the cabinetry,by turning the
feet from inside the product using a wrench or M5 socket.
TIP - gently take the load off each foot using the slide and
then turn by hand.
NOTE." For integrated products, the upper pane/may be
a/igned with the top of the adjacent cabinetry, provided
a minimum 3/16"
(5mm)
c/earance from the counter is
maintained.
Important!
The productmust be levelled to within
3/32"
(2.Smm) from front to
back, and side to side.
Important!
The productshould NOT support any part of the kitchen cabinetry.
TIP- Place a spirit level on the drawer runners to level the
product.
STEP4:
SECURINGTHE PRODUCT
_]_ SINGLE MODELS ONLY
Checkthe position of the chassis is still where marked on the cavity,
before securingthe product.
Thereare four 5/8" (16mm) round holes,two on the left andtwo on
the right hand side in the sound insulation. Theseprovide access to
the mounting tabs.
Tosecure the product to the cabinetry use a 5/8" (16mm)
Phillips screw in each mounting tab.
Make sure the sound insulation is positionedcorrectly before
continuing installation.
_ DOUBLE MODELS ONLY
Screw the two top tabs to the undersideof bench. Usethe supplied
Phillips5/8" (16mm) screws. Tabscan accommodatea maximum of
3/4" (19mm) vertical gap.