Port Connection Specification; Pin Specification Of Ports - D-Link DI-2000 Series User Manual

7 BRI S/T
8 ACTIVE
9 TR

3.3 Port Connection Specification

3.3.1

PIN Specification of Ports

The DI-2006 router has a serial port, a Ethernet port and a ISDN S/T interface. PIN
description of each port is as follows:
1. Serial ports
The DI-2006 router has one serial port. The jacks are three rows, 44 pins and high
density. They can be deployed to be synchronous or asynchronous methods, so they
can connect to synchronous MODEM(such as TAINET T-1496) or asynchronous
MODEM(such as 3Com USR) for entering special networks. For synchronous method,
the DI-2004 router also support the physical protocol of V.35, capable of connecting to
baseband MODEM(such as ASCOM AM64000A ) with a maximum speed of 2Mbps to
achieve the high-speed access goal.
PIN description of serial ports on the DI-2006 is shown asTable 3-1:( PIN in the table
and figure is signed in corresponding location of the jack)
2. The Console port
The DI-2006 router has a Console port with the standard RJ45 jack. The port is
connected to terminals(such as STAR-510G
Console cable, then terminal emulate software can be used to deploy and monitor the
DI-2006 router.
Pin description is shown as Figuer 2-3.
3. Ethernet port
The Ethernet port of the DI-2006 router offers two physical interfaces:
AUI(Attachment Unit Interface) and TP interface(twisted-pair interface). While used,
the router can connect to HUB from TP interface through twisted-pair cable, or the
router can connect to HUB, thin cable or thick cable from AUI through a special switch
box. Pin number order of TP interface is the same to Console port. Its distribution is
shown as Figure 1-2-3.
Pin description of TP interface(twisted-pair interface) is shown as Table 2-5.
ISDN BRI S/T Connect to S/T interface( RJ45) of ISDN network
interface terminal(NT1) through the port
ISDN BRI S/T When the line is enabled and D channel is active, the
interface is active indicator will glint.
TR should be set as ON under point-to-point
Selective switches communication. TR of two general bus terminal
of 100Ω terminal should
resistance communication , while other DI-2006 routers should
be set as OFF.
DI-2000 Series Routers hardware installation manual
be set as ON
+
) or serial ports of PC with the special
under general bus
- 18 -