Chapter 4 Installation Of The Routers - D-Link DI-2000 Series User Manual

Chapter 4 Installation of the Routers

4.1 Installation Specification
Figuer 4-1 Installation Figure of the DI-2000 Series
Installation steps of the DI-2000 is shown as numbers of Figuer 4-1.
(1) Install the upper panel from the top down. Ensure mesh between teeth of frames
and edges of the nether panel .
(2) Push the upper panel from the front back and ensure mesh between the back
edge of the upper panel and the upper edge of the nether panel.
(3) Fix screws on the nether edge of the two sides on the upper panel. ¢ Û
figure only shows the right side, the same to the left.
Notice:
Danger! Within the router, there is dangerous voltage harmful to people. Don't open the panel except
maintenance organizations authorized by company. Or else, all serious results should be assumed by
self.
4.2 Mount the Routers in a Standard Rack
There are two methods to attach brackets to the DI-2000 Series of routers as shown in
Figuer 4-2 and Figuer 4-3 For the first method, first use screws to fix brackets on the
two sides of the DI-2000 Series with the front panel forward (Figuer 4-2 only shows the
right attachment, the same to the left). Then attach brackets to the rack according to
Figuer 4-4.. For the second mounting method, use screws to fix brackets on the two
sides of the DI-2000 Series with the rear panel forward (Figuer 4-3 only shows the right
attachment, the same to the left). Then attach brackets to the rack according to Figuer
4-4.
Figuer 4-2 The First Attaching-Brackets Method
DI-2000 Series Routers hardware installation manual
in the
- 23 -