Electrolux EI30DS55JS1 Installation Instructions Manual page 3

To avoid breakage: Do NOT handle or
manipulate the unit by the cooktop.
The counter-top around the cut-out should be flat and
leveled (see hatched area on illustration 1).
Before installing the unit, measure the heights of the two (2)
cabinet sides (H1-4), front and back (see illustration 1) from the
floor to the top of the counter.
Level the range using the
two (2) front leveling legs
and the two (2) adjustable
leveling wheel, so that the
height from the floor to
the underside of the metal
flange is greater than the
tallest cabinet measurement
(see illustration 2).
Shave 1 1/2"Max. 1
(3.8 cm Max.) I
Raised
Edge
to Clear
Space for a
311/2" (81 cm) Wide
Cooktop.
by at least 1/16"
Illustration 1
Remove and discard the two rear leveling legs,
they are only in place to solidify the unit for the transport.
Slide the unit into the cabinet. Make sure the center of the unit is
aligned with the center of the cabinet cut-out.
Remove the protective channels on each side of the cooktop
(if provided).
The metal flange under each side of the cooktop MUST be
placed over the cabinet countertop for proper unit support.
The cooktop should NOT rest directly on the countertop (see
illustration 2) or else it could cause damage to the cooktop
voiding the warranty. Level the unit if needed
After the installation, MAKE REthat the
unit is supported by the two front leveling
legs and the two adjustable leveling wheels
and NOT by the cooktop
To successfully install
the range, the initial
level height from
floor to underside
of cooktop frame
should be at least
/16" taller than
sides as
measured in step 2.
Illustration 2
3