NEC MultiSync LCD1810 User Manual page 30

E - 12
To attach the MultiSync LCD2010 monitor to your system,
follow these instructions:
1. Turn off the power to your computer.
2. For the PC: Connect the 15-pin mini D-SUB of the appropriate
signal cable to the connector of the display card in your
computer(Figure G.1). Tighten all screws.
For the Mac: Connect the MultiSync Macintosh cable adapter
to the computer(Figure H.1). Attach the 15-pin mini D-SUB
end of the appropriate signal cable to the MultiSync Macintosh
cable adapter (Figure H.1). Tighten all screws.
3. Remove connector cover on back of monitor. Connect the BNC
cables and AC adapter cable to the appropriate connectors on
the back of the monitor. Connect the red BNC cable to the
BNC connector on the monitor labeled R, the green BNC cable
to the BNC connector labeled G/Sync, the blue BNC cable to
the BNC connector labeled B. If you have a fourth BNC
connector (Composite Sync), connect it to the BNC connector
on the monitor labeled HS/CS. If you have a fifth BNC
connector (Vertical Sync), connect it to the BNC connector on
the monitor labeled VS (Figure I.1). Place the 15-pin VGA to
BNC Cable under clip A (Figure J.1A). Then place the 15-pin
VGA to BNC cable under Clip B (FigureJ.1B). Replace
connector cover.
NOTE: Incorrect cable connections may result in irregular operation,
damage display quality/components of LCD module and/or shorten the
module's life.
4. Connect one end of the power cord to the AC Adapter and the
other end to the power outlet (Figure K.1).
5. Turn on the monitor (Figure L.1) and the computer.
78133813.PM5 30
Installation
99.11.10, 1:40 PM