Motorola ASTRO XTL 2500 User Manual page 157

®
ASTRO XTL™ 2500 Digital
Mobile Radio with M5
Control Head
M5 Quick Reference Card
Product Safety and RF Exposure Compliance
Before using this product, read the operating instructions
!
for safe usage contained in the Product Safety and RF
Exposure booklet enclosed with your radio.
C a u t i o n
ATTENTION!
This radio is restricted to occupational use only to satisfy
FCC RF energy exposure requirements. Before using this
product, read the RF energy awareness information and
operating instructions in the Product Safety and RF
Exposure booklet enclosed with your radio (Motorola
Publication part number 6881095C99) to ensure
compliance with RF energy exposure limits.
DIM
BUTTON
VOLUME
KNOB INDICATORS
HOME
POWER SOFT MENU
ON/OFF KEYS
BASIC OPERATION
Turning the Radio On and Off
Press the Pwr button once.
Setting the Volume and Squelch
1 Turn the Vol knob clockwise to increase volume or
counterclockwise to decrease volume as desired.
2 On conventional modes with Private-Line or Digital
Private-Line, press MON softkey to defeat the coded
squelch.
3 Press MON softkey again to return to coded-squelch
operation.
4 To adjust squelch level, hold MON softkey until a tone
sounds.
5 Rotate the Mode knob clockwise to increase squelch
level or counterclockwise to decrease squelch level.
6 Press Home button to save the squelch level.
Changing Modes
Rotate the Mode knob to select the desired mode.
EMERGENCY OR
Emer
MODE
Press Home button to access the preprogrammed
KNOB
Home mode.
XTL 2500
Transmitting
1 Press and hold the microphone PTT button.
2 When the transmit light comes on solid and no alert
tones sound (or a talk-permit tone or ID sidetone
sounds), speak into the microphone in a normal voice.
NAVIGATION
KEYS
3 State your FCC call sign at the beginning of each
transmission.
Transmitting (Conventional Modes)
1 Press Dir (Direct) softkey. The Dir indicator lights.
2 Press Dir softkey again to return to repeater
operation.
Activating Scan
1 Press Scan softkey to start a scan. If no activity
exists, the display shows your selected mode. When
a scanned channel or talkgroup becomes active, the
display shows the active mode name. The PRI and
NPRI indicators show priority.
2 Press Scan softkey again to stop scanning.
Programming a Scan List
1 Press Prog softkey followed by Scan softkey until the
scan list is being displayed and the scan indicator
blinks.
2 Use the navigation keys to select the mode you want
to program.
3 Press the Sel softkey as indicated in the table below
to add or remove the displayed mode from the scan
list.
4 Repeat the previous steps to continue editing the list.
5 Press Home button to exit.
Press Sel Mode
One time Non-Priority
Two times Second Priority
Three times First Priority
Four times Delete from List
Selecting Scan Mode Priority
1 Press the Sel softkey as indicated in the table above
to designate up to two modes as priorities.
2 Press Home or Scan to end scan list selection.
Indicator
NPRI lit
PRI lit
PRI blinks
No indicator