Configuring Role Based Access Control For Windows Server 2003 - Oce im2330 Network Administration Manual

Configuring Role Based Access Control for Windows Server 2003

This section describes how to set up the Role Access Based Control for a Windows Server 2003
as an example. Please set up the server in your accountability.
To configure the schema for Role Based Access Control, you must create a schema first.
P.39 "Creating the schema for Role Based Access Control"
Then configure the attribute value for each user.
P.41 "Configuring attribute value for each user"
Creating the schema for Role Based Access Control
Before adding the schema for Role Based Access Control for Windows Server 2003, you must
install the Administration Tools Pack. The installation method varies depending on whether the
Service Pack is installed or not.
- When the Service Pack 1 is not installed:
Right-click the "adminpak.msi" file in the "i386" folder in the Windows Server 2003 CD-ROM
and select [Install].
- When the Service Pack 1 is installed:
Right-click the "adminpak.msi" file in the "WINDOWS\system32" folder in the local disk and
select [Install].
1
Click the [Start] menu and select [Run...].
The Run dialog box appears.
2
Enter "mmc /a" and click [OK].
The Console1 window appears.
3
Click the [File] menu and select [Add/Remove Snap-in...].
The Add/Remove Snap-in dialog box appears.
4
Click [Add] in the [Standalone] tab.
The Add Standalone Snap-in dialog box appears.
5
Select "Active Directory Schema" and click [Add]. Then click
[Close].
It returns to the Add/Remove Snap-in dialog box.
6
Confirm that "Active Directory Schema" is added in the list and
click [OK].
It returns to the Console1 window.
7
Right-click "Active Directory Schema" in the left pane of the
Console1 window and select [Change Domain Controller...].
The Change Domain Controller dialog box appears.
Setting up Role Based Access Control 39