General Maintenance; Declaration Of Conformity - Terratek TT8503T User Manual

Disposal of the exhausted battery
WARNING:
Do not dispose of the exhausted battery. The battery must explode if it is
incinerated. The product that you have purchased contains a rechargeable battery. The battery is
recyclable. At the end of its useful life, under various state and local laws, it may be illegal to
dispose of this battery into the municipal waste stream. Check with your local solid waste officials
for details in your area for recycling options or proper disposal.
Disposal
Power tools, accessories and packaging should be sorted for environmentally-friendly recycling.
Only for EC countries:
Do not dispose of power tools into household waste!
According to the European Directive 2002/96/EC on waste electrical and electronic equipment
and its incorporation into national right, products that are no longer suitable for use must be
separately collected and sent for recovery in an environmentally-friendly manner.
Battery packs/batteries:
Li-Ion:
Do not dispose of battery packs/batteries into household waste, water or fire. Battery
packs/batteries must be collected, recycled or disposed of in an environmentally-friendly way.
Only for EC countries:
Defective or dead batteries must be recycled according to the directive 2006/66/EC.
Accessories
CAUTION: Use only accessories or attachments recommended for use with your Terratek tool
specified in this manual. The use of any other accessories or attachments might present a risk of
injury to persons. Only use accessory or attachment for its stated purpose.

General Maintenance

1. Keep the air vents free from obstruction and clean regularly.
2. Check regularly for any dust particles entering the grills around the motor and the switch. Use a
soft brush to remove any dust particles. Wear safety glasses to protect your eyes whilst cleaning.
3. Monitor the dust bag (if equipped) and empty when approximately half full. Always empty into
an appropriate container. REMEMBER: dust can be hot and cause fire.
4. If the cutting tool has become dull, replace it. Dull cutters will cause increased tear-out and
ragged edges on the cuts.
5. Lubricate all moving parts at regular intervals.
6. To clean the body of the power tool, only use a soft damp cloth. Do NOT immerse in water. A
mild detergent can be used but NOT petrol or any alcohol based product.
7. Should the power cord become damaged only allow a fully qualified electrician to replace or
repair.

Declaration of Conformity

We ACL Group (Intl.) Ltd, England DN6 8LZ declare that the Oscillating Tool has been
manufactured according to our full quality assurance procedures.
The declaration is to certify that it conforms to CE, EMC, LVD and RoHS directives:
EN55014-1:2006
EN55014-2:1997 /+A1:2001 /+A2:2008