Package Contents - Terratek TT8503T User Manual

Wear protective gloves when changing cutting accessories. Accessories become hot after
prolonged usage.
Use thick cushioned gloves and limit the exposure time by taking frequent rest periods.
Vibration caused by the tool may be harmful to the hands and arms.
Before scraping, check work piece for nails. If there are nails, either remove them or set
them well below intended finished surface.
Striking a nail with accessory edge could cause the tool to jump.
Do not wet sand with this tool. Liquids entering the motor housing is an electrical shock hazard.
Never work in area which is soaked with a liquid, such as a solvent or water, or
dampened such as newly applied wallpaper. There is an electrical shock hazard when working
in such conditions with a power tool and heating of the liquid caused by scraping action may cause
harmful vapors to be emitted from work piece.
Always wear eye protection and a dust mask for dusty applications and when sanding
overhead. Sanding particles can be absorbed by your eyes and inhaled easily and may cause
health complications.
Use special precautions when sanding chemically pressure treated lumber, paint that
may be lead based, or any other materials that may contain carcinogens. A suitable
breathing respirator and protective clothing must be worn by all persons entering the work area.
Work area should be sealed by plastic sheeting and persons not protected should be kept out until
work area is thoroughly cleaned.
Do not use sandpaper intended for larger sanding pads. Larger sandpaper will extend beyond
the sanding pad causing snagging, tearing of the paper or kick-back. Extra paper extending beyond
the sanding pad can also cause serious lacerations.
WARNING: Some dust created by power sanding, sawing, grinding, drilling, and other
construction activities contains chemicals known to cause cancer, birth defects or other
reproductive harm. Some examples of these chemicals are:
Lead from lead-based paints,
Crystalline silica from bricks and cement and other masonry products, and
Arsenic and chromium from chemically treated lumber.
Your risk from these exposures varies, depending on how often you do this type of work. To reduce
your exposure to these chemicals: work in a well ventilated area, and work with approved safety
equipment, such as those dust masks that are specially designed to filter out microscopic particles.
Unpacking
Carefully remove the product and any accessories from the box. Make sure that all items listed in
the packing list are included.

Package contents

A) Tool
B) Blades
C) Wrench
D) Bolt
E) Rubber backing pad
F) Sand paper
G) User manual
Functional Description
WARNING: Disconnect the plug from the power source before making any
assembly, adjustments or changing accessories. Such preventive safety measures reduce the
risk of starting the tool accidentally.
CAUTION: Blades are sharp, handle with care. Wear protective
gloves when changing tools.
(Fig.1)