On-Off Switch - Terratek TT8503T User Manual

Assembly
1. Turn the Power Switch off and unplug the tool.
2. Place the attachment over the Spindle, shoulder facing away from the tool. Line up the holes on
the attachment with the pins on the Spindle shoulder.
Note: The Angled Cutter Blade should only be used in the straight ahead position and not an
angled position. (Fig.3)
3. Place the Small Washer and then the Large Washer onto the Cap Screw (cupped side facing up)
(Fig.2). While holding the attachment over the pins on the tool spindle, thread the Cap Screw in
place.
4. Tighten the cap screw onto the Spindle using the provided Hex Key. (Fig.3)
5. After securing, the attachment should not move on the spindle. If it does move with the power
off, remount it, making sure that the holes on the attachment line up with the pins on the spindle.
Tighten the cap screw securely.

On-Off Switch

Ensure that the switch is in the "OFF" position. If the plug is connected to a receptacle while the
switch is in the "ON" position, the power tool will start operating immediately and can cause
serious injury.
The tool is switched "ON" by the slide switch located on the topside of the motor housing.
TO TURN THE TOOL "ON", slide the switch button forward.
TO TURN THE TOOL "OFF", slide the switch button backward.
Variable speed control dial
This tool is equipped with a variable speed control dial (Fig.5). The speed may be controlled during
operation by presetting the dial in any one of six positions, 1 being the lowest, and 6 being the
highest.
Battery use and care
A battery operated tool with integral batteries or a separate battery pack must be
recharged only with the specified charger for the battery.
A charger that may be suitable for one type of battery may create a risk of fire when used with
another battery.
Use battery operated tool only with specifically designed battery pack.
Use of any other batteries may create a risk of fire.
NEVER place hands or other body parts near the drill bit or chuck during operation.
Hold the drill by its handle only. Because the cordless driver drill operates by battery power, be
aware of the fact that it can begin to operate at any time.
WARNING: Improper use of the battery or battery charger can lead to serious injury.
To avoid these injuries:
A) NEVER disassemble the battery.
B) NEVER incinerate the battery, even if it is damaged or is completely worn out.
The battery can explode in a fire.
C) NEVER short-circuit the battery.
D) NEVER insert any objects into the battery charger's air vents. Electric shock or
damage to the battery charger may result.
E) NEVER charge outdoors. Keep the battery away from direct sunlight and use only
where there is low humidity and good ventilation.
F) NEVER charge when the temperature is below 32°F (0°C) or above 104°F (40°C).
G) NEVER connect two battery chargers together.
H) NEVER insert foreign objects into the hole for the battery or the battery charger.
I) NEVER use a booster transformer when charging.
J) NEVER use an engine generator or DC power to charge.
K) NEVER store the battery or battery charger in places where the temperature may
reach or exceed 104°F (40°C).
L) ALWAYS operate charger on standard household electrical power (120 volts).
Using the charger on any other voltage may overheat and damage the charger.
M) ALWAYS wait at least 15 minutes between charges to avoid overheating the charger.
(Fig.4)