Procedure 4-7: Restore A Configuration From A File; Procedure 4-8: Erase The Configuration - NETGEAR FR328S Reference Manual

Procedure 4-7: Restore a Configuration from a File

Log in to the firewall at its default LAN address of http://192.168.0.1 with its default User
1.
Name of , default password of
admin
address you have chosen for the firewall.
From the Maintenance heading of the Main Menu, select the Settings Backup menu as seen in
2.
Figure 4-7.
Enter the full path to the file on your network or click the Browse button to browse to the file.
3.
When you have located the
4.
The firewall will then reboot automatically.
5.

Procedure 4-8: Erase the Configuration

It is sometimes desirable to restore the firewall to the factory default settings. This can be done by
using the Erase function.
To erase the configuration, from the Maintenance menu Settings Backup link, click the Erase
1.
button on the screen.
The firewall will then reboot automatically.
2.
After an erase, the firewall's password will be password, the LAN IP address will be
192.168.0.1, and the router's DHCP client will be enabled.
Note: To restore the factory default configuration settings without knowing the login password or
IP address, you must use the Default Reset button on the rear panel of the firewall. See
Default Reset button" on page
Managing Your Network
FR328S Cable/DSL ProSafe Firewall with Dial Back-Up
password
file, click the Restore button to upload the file to the firewall.
.cfg
6-8.
, or using whatever Password and LAN
"Using the
4-11