Preparation Before Use; Usage - Haier PRCS25 Series User Manual

Preparation Before Use

Remove all packing materials,
including foam, base pads,
and tape used to attach
accessories.
Removing and Installing Handles:
Note: Remove protective plastic covering from all handles.
1. Refrigerator and Freezer Door Handles Installation
a) Handles are packed inside the fresh food compartment.
b) Carefully remove the handles from the packing material.
c) Position the long handle marked REF TOP to the right door of the refrigerator.
d) Align the handle onto the handle bolts.
e) Pull the handle downward until handle locks in place.
f) Repeat steps above for long freezer door handle (FRZ TOP).
2. Convertible Drawer Handle Installation
a) Position the short handle onto the Convertible Drawer Bolts (slight horizontal bend upward).
b) Pull the handle to the left until handle locks in place.
3. Removing Handles Follow opposite Process
4. Door bin Installation
a) Remove 4 door bins from inside the fresh food and freezer compartments.
b) Carefully remove all protective wrappers.
c) Position the narrow bins (2L) onto the lower door liner tabs of the fresh food door to clear crispers properly.
d)Position bins down over tabs to lock in place.
e) Position the remaining bins as shown.
Copy the refrigerator model number and manufacturer's serial number for all service calls or
inquiries you may have in the future.
NOTE
It is recommended to clean the refrigerator
before use. Mix 4 liters of water with 1 tsp
baking soda. Wipe the interior and exterior
with a soft cloth moistened with this mixture.

Usage

Connecting the power:
The default temperatures for all three
compartments are set at the middle range
for freezer, fresh food, and convertible
drawer as a fresh food compartment.
Put food inside the refrigerator:
After the refrigerator has been plugged in and is fully
cooled, it is safe to put in food and begin use.
Check accessories and
documents: Check materials
against the packing list. If any
are different section or missing,
inquire with the retailer.
After the refrigerator is put into place, adjusted,
and cleaned, connect the power to begin
normal operation.
Refrigerator work mode:
Manual adjustment: Set the temperature by
pushing the temperature adjusting button. (Refer
to "Function" section page 10.) Convertible drawer
is set in the refrigerator mode by the factory.
Every time the temperature settings
are changed, it takes some time for the
temperature to adjust. The length of
time depends on the amount of change,
the ambient temperature, frequent door
NOTE
openings, quantity of stored food, etc.
9
Put the refrigerator in
a proper place (Refer to
"Location" section page 3.)