TC-Helicon VoiceWorks User Manual page 19

VOICES & EFFECTS EDIT PARAMETERS
R T
EVERB YPE
The list of reverb types includes the following
acoustic simulations:
Living Room, Chamber, Club, Classic Hall,
Concert Hall, Large Cathedral, Vocal Studio,
Vocal Room, Vocal Hall, Ambience, Live
Reverb, Plate1, Plate2, and Spring.
R P D T
EV RE LY
Reverb Pre-delay time. Sets the delay time
prior to the reverb output. Large rooms
typically have reverbs that start much later
than the initial signal.
D
ECAY
Reverb Decay Time.
L
Reverb Low Color. Specifies the characteristics
of the reverbs low frequencies.
H
Reverb High Color. Specifies the
characteristics of the reverbs high frequencies.
D T
ELAY YPE
DualMono Delay- maintains the panning of the
sends.
PingPong1 sends the lead voice to the left
effect end only.
PingPong2 sends the lead voice to the sends
depending on the lead pan setting.
Dual Mono Delay
Left Delay Send
HF Damping
Right Delay Send
HF Damping
Delay Left Delay Out
Feedback
Amount
Delay
Right Delay Out
PingPong1 and PingPong2 Delay
ay Send
HF Damping
Feedback
Amount
ay Send
HF Damping
D (ms)
LY
Using the DATA WHEEL, you can fine adjust
the current delay time.
D T S
ELAY EMPO OURCE
TAP: the DLY time comes from the last tapped
tempo.
MCLK: the Dly time comes from incoming MIDI
clock messages.
IGNORE: the Dly time always comes from the
value manually entered into preset using the
DATA WHEEL.
D T R
ELAY EMPO ATIO
Sets the ratio between the Tapped or MIDI
tempo and the resulting delay.
With TAP selected as a tempo source, the
tempo may be tapped in when any of the
three above parameters are selected.
FB
Delay feedback amount.
D
High Frequency Damping.
Delay Left Delay Out
Delay
Right Delay Out
17