How To Setup The Access Point For Wpa With 802.1X Session Keys - 3Com WL-455 User Manual

11 The Access Point is now configured for RADIUS Authentication.
H
OW TO SETUP THE ACCESS POINT FOR
S
ESSION KEYS
1
2
3
4
5
6
7
8
9
10 Make sure the following settings are set from the Security page:
d Cipher Mode is set to WEP.
e WEP Configuration has at least one valid WEP key.
f Click on Apply.
Using the Wireless Infrastructure Device Manger access the configuration screen
for the AP8x00/AP82x0.
Enter your User Name and Password and click LOGIN (Default: admin with no
password).
Select Advanced Setup.
Click on RADIUS from the left frame page Menu.
Enter all the settings of your Primary RADIUS Authentication Server (make sure
the IP Address and Key match those on the RADIUS Authentication software).
Click on Apply.
Choose Authentication from the left frame page Menu.
Make sure the following settings are set on the Authentication page:
a MAC Authentication is Disabled. (if Local or RADIUS MAC Authentication
is chosen MAC address filtering or authentication, respectively, will be done
before the 802.1x authentication. Therefore, these setups must be validated
individually and verified functional before 802.1x can be done).
b 802.1x Wireless Setup: is set to Optional (if non-RADIUS clients need access
too) or Required (if only RADIUS clients are to be allowed).
c Click on Apply.
Click Security on the 802.11b/g radio from the left frame page Menu.
a Authentication is set to Open System.
b Encryption is Enabled.
c WPA Configuration is Checked to "Allow only WPA Clients".
d Cipher Mode is set to AES/TKIP/WEP (WEP Cipher Mode is intended ONLY
for support of legacy clients. If only WPA clients are on the network, choose
AES or TKIP for increased security).
e WEP Configuration has at least one valid WEP key.
WPA
45
802.1
WITH X