Using An Optional Power-Over-Ethernet Injector; Using A Power-Over-Ethernet Lan Port - 3Com WL-455 User Manual

U A O
SING N
CAUTION: To avoid damaging network equipment, make sure that the cables are
!
connected from access point to power supply to LAN as shown above and
described below.
The Power-Over-Ethernet Injector can be located at any point between the access point
and the LAN access port, wherever a convenient power outlet exists. If you supply
your own Ethernet cable for connecting power, be sure that it is standard category 5
straight-through (8-wire) cable that has not been altered in any way. Use of
nonstandard cable could damage the access point.
Refer to the illustration below, and follow these steps:
1 Connect one end of the Ethernet cable to the Ethernet port on the access point.
2 Connect the other end of the Ethernet cable to the port labeled To Access Point on
the power supply.
3 Connect the power cord to the power supply and plug the cord into a power outlet.
4 To link the access point to your Ethernet network, plug one end of another
Ethernet cable into the port labeled To Hub/Switch on the power supply, and plug
the other end into a LAN port (on a hub or in a wall).

Using an Optional Power-over-Ethernet Injector

P
PTIONAL OWER
16
-O -E
VER THERNET
Using an Optional Power-over-Ethernet
I
NJECTOR
LAN Port