D-Link DSL-2750E User Manual page 83

DSL-2750E User Manual
Click Add below the table IPTUNNEL to add tunnel items. The page shown in the
following figure appears.
The following table describes the parameters of this page.
Field
Tunnel Name
Tunnel Mode
Wan Interface
Lan Interface
Click Apply to enable the settings.
Click Add below the table DS-Lite IPv4 over IPv6 Tunnel List to add a DS-Lite
item，which is a 4in6 tunnel. The page shown in the following figure appears.
The following table describes the parameters of this page.
Field
Mechanism
Dynamic
RemoteIPv6Address
Set a tunnel name.
Select the tunnel mode as 4 in6 or 6in4.
Choose a WAN interface used for the tunnel.
Choose a LAN interface used for the tunnel.
The tunnel type is DS-Lite, which is 4in6 tunnel.
Set the obtaining mode of remote IPv6 addresses.
You can select 0 or 1.
Set the remote end IPv6 address of the tunnel.
80
Description
Description