Honeywell Domonial User Manual page 10

To reset the system follow the disarming procedures using either your code or keytag four times
consecutively. Ensure the audible disarm tone sounds after each disarming procedure.
If the two red LEDs
alarm has occured and a remote reset is required and the system will not operate. To remotely reset
your system call your Service Department :
CHANGING OR SETTING ADDITIONAL CODES
To change or set additional user codes firstly enter programming mode
+
Press key :
The red light will flash slowly
Enter the 4 digit master code (user 1)
Select and enter an existing or new single digit user ID (0-9)
(N.B. : User 1 is always the master)
Enter the new 4 digit code for this user
A double beep on the keypad will confirm acceptance of the new code.
You must confirm the new code by re entering the 4 digits numbers.
A double beep on the keypad will confirm acceptance of the new code.
Exit programming mode by pressing
CHANGING OR SETTING ADDITIONAL KEY TAG
A key TAG can only be programmed to an existing user's 4 digits code.
To change or set additional key TAG firstly enter programming mode
+
Press key :
The red light will flash slowly
are illuminated on your alarm panel, this indicates a confirmed
simultaneously
key.
simultaneously
10