Table of Contents
Advertisement
5. Place the chimney onto the hood body, ensuring it fits into the gap
on the top of hood body.
6. Slide the chimney extensions upward and secure the upper chimney to
the chimney support bracket using two 4 mm x 8 mm tapping screws.
CAUTION: Minimize movement of the chimney extensions to avoid
scratches.
ExHAUST VENTING
Ducted mode air exhaust system
Caution: To reduce the risk of fire, use metal duct work only.
1. Decide where the duct work will run
between the hood and the outside.
2. A straight, short duct run will allow the
hood to perform most efficiently.
3. Long duct runs, elbows, and
transitions will reduce the performance
of the hood. Use as few of them
as possible. Larger ducting may be
required for best performance with
longer duct runs.
4. Attach an adequate length of 15 cm
round duct to the air outlet adapter
(Not supplied).
5. The air must not be discharge into a
flue that is used for exhausting fumes
from appliances burning gas or other
fuels. Follow all regulations concerning
the discharge of air.
6. Install a roof/wall cap. Connect round
metal duct work to cap and work back
towards hood location. Use duct tape
to seal the joints between duct work
sections.
15
Hide quick links:
Advertisement
Table of Contents
