nexstyle 4OSA015BST Installation Manual And User's Manual page 11

Duct Cover
x 1 set
Aluminum
Exhaust Duct
* Proper installation is your responsibility - Have a qualified technician install this range hood.
* Read the entire installation guide and user manual thoroughly, and understand instructions and warnings.
* PERSONAL INJURY HAZARD - Because of the weight and size of the range hood, two or more people
are needed to move and safely install the range hood. Failure to properly lift range hood could result in
damage to the product or personal injury.
* All openings in ceiling and wall where range hood will be installed must be sealed.
* Range hood location should be away from strong draft areas (windows, doors and strong heating vents).
* SEVERE INJURY - Rotating fan can cause severe injury. Stay clear of fan when motor is running.
* SEVERE INJURY - Range hood may have very sharp edges. Please wear protective gloves to remove
any parts for installing, cleaning or servicing.
NOTE:
• Before making cuts, make sure there is proper clearance within the ceiling or
wall for exhaust vent.
• Check your ceiling height and the hood height maximum before you select and
install your hood.
• The hood should be installed between 46 cm (18 in) and 75 cm (29.5 in) above
the counter top.
• Toggle bolts are provided to secure the hood to most wall types. However,
a qualified technician must verify suitability of the bolts, screws and drywall
anchors with your wall type.
• Put a thick, protective covering over your counter top, cook top or range to
protect from damage and dirt. Remove any hazardous objects around the area
when installing.
• Due to the size and weight of this range hood, the supports must be firmly
attached to the wall.
• For plaster or sheet rock walls, the support must be attached to the studs.
If this is not possible, a support structure must be built behind the plaster or
sheet rock. The manufacturer assumes no responsibility for injury or damage
caused by improper installation.
Hood Body x 1
Parts Bag
WARNING
Installation
Guide x 1
Chimney Support
Bracket x 1
Hood
Brackets
x 2
Duct Clamp
x 1
M4 x 8mm
Tapping Screws
x 2
Toggle Bolts
x 4
M5 x 16mm
Screw/Washer
x 4 Sets
11