Download Print this page

Zanussi ZCV665 User Manual page 19

Electric cooker
Hide thumbs

Advertisement

Minimum distances
Dimension
A
B
Levelling
Use small feet on the bottom of appliance to
set same level of cooker top surface with other
surfaces
The anti-tilt protection
Caution! You must install the anti-tilt
protection (A+B). If you do not install it the
appliance can tilt.
Before you install anti-tilt protection, adjust the
appliance to the correct height.
The anti-tilt protection has two parts (A+B).
You can find the anti-tilt protection (B) on right
or left side of the rear wall of the appliance
(See fig. 1). You must install the anti-tilt protec-
tion (A) on the wall. The distance of the hole of
www.zanussi.com
B
A
A
mm
2
685
the anti-tilt protection (A) from the floor is about
816 mm. Make sure you install the anti-tilt pro-
tection (A) at the correct height. Screw it into
the solid material or use applicable reinforce-
ment.
Check that the anti-tilt protection projects mini-
mum 20 mm into the hole in the back of the ap-
pliance (B) when you push the appliance (See
fig. 2). If the space between the bench cup-
boards is greater than the width of the appli-
ance, you must adjust the side measurement to
centre the appliance. Make sure that the sur-
face behind the appliance is smooth.
1
2
Electrical installation
Warning! Only a qualified and competent
person must do the electrical installation.
The manufacturer is not responsible if you
do not follow safety precautions from the
chapter "Safety information".
This appliance is supplied without a main plug
or a main cable.
Covering terminal board
The recommended cross-section area is six
square millimetres (6 mm²).
When you refit the mains terminal cover, make
sure that the lower tabs are located inside the
bottom edge of the aperture, before you fix the
60 mm
50 mm
A
B
19

Advertisement

loading

  Also See for Zanussi ZCV665

  Related Manuals for Zanussi ZCV665