Setting Time; Radio; Listening To Radio - Alpine CDE-W203E Owner's Manual

Setting Time

1
Press and hold SETUP for at least 2 seconds to
activate the SETUP mode.
2
Turn the Rotary encoder to select the CLOCK ADJ
mode, and then press
The time indication will blink.
3
Turn the Rotary encoder to adjust the hours.
4
When the hour has been adjusted, press
5
Turn the Rotary encoder to adjust the minutes.
6
Press and hold SETUP for at least 2 seconds to
return to normal mode.
• To synchronize the clock to another clock/watch or radio time
announcement, press and hold
setting the "hour." Minutes will reset to "00". If the display shows
over "30" minutes when you do this, the time will advance one hour.
• Pressing /ESC will return to the previous mode.
• If no operation is performed for 60 seconds, the unit will return to
normal mode automatically.
Controllable with Remote Control
This unit can be controlled with an optional Alpine remote
control. For details, consult your Alpine dealer.
Point the optional remote control transmitter at the remote
control sensor.
Remote control sensor
Connectable to Remote Control Interface Box
This unit may be controlled from the vehicle's audio controls.
An optional Alpine Remote Control Interface Box must be
used. For details, contact your Alpine dealer.
/ENT.
/ENT.
/ENT for at least 2 seconds after

Radio

Preset buttons
(1 through 3)
BAND
SOURCE/ TUNE/A.ME

Listening to Radio

1
Press SOURCE/ to select TUNER mode.
2
Press BAND repeatedly until the desired radio band
is displayed.
F1 (FM1) F2 (FM2) AM
3
Press TUNE/A.ME to select the tuning mode.
DX SEEK (Distance mode)
OFF (Manual mode) DX SEEK
• The initial mode is Distance mode.
Distance mode:
Both strong and weak stations will be automatically tuned in
(Automatic Seek Tuning).
Local mode:
Only strong stations will be automatically tuned in (Automatic
Seek Tuning).
Manual mode:
The frequency is manually tuned in steps (Manual tuning).
4
Press or to tune in the desired station.
Holding down or
continuously.
Preset buttons
(4 through 6)
F1 (FM1)
SEEK (Local mode)
will change the frequency
7
-EN