Installation - Alpine CDE-W203E Owner's Manual

Installation

Caution
Do not block the unit's heat sink, thus preventing air
circulation. If blocked, heat will accumulate inside the
unit and may cause a fire.
• The main unit must be mounted within 30 degrees of the horizontal
plane, back to front.
Less than 30°
1
Remove the mounting sleeve from the main unit (see
"Removal" on page 26). Slide the unit into the
mounting sleeve and secure it.
Mounting Sleeve
(Included)
Pressure Plates
26
-EN
Heat sink
Dashboard
This unit
Face Plate (Included)
2
Hex Nut (M5)
Metal
Mounting
Strap
Ground Lead
Reinforce the head unit with the metal mounting
strap (not supplied). Secure the ground lead of the
unit to a clean metal spot using a screw (
attached to the vehicle's chassis.
2
• For the screw marked "* ", use an appropriate screw for the chosen
mounting location.
Connect each input lead coming from an amplifier to
the corresponding output lead coming from the left
rear of the CDE-W203E. Connect all other leads of
the CDE-W203E according to details described in
the CONNECTlONS section.
3
Slide the CDE-W203E into the dashboard until it
clicks. This ensures that the unit is properly locked
and will not accidentally come out from the
dashboard.
Removal
1. Insert the bracket keys into the unit, along the guides
on either side. The unit can now be removed from the
mounting sleeve.
This unit
2. Pull the unit out, keeping it unlocked as you do so.
Screw
2
*
Bolt Stud
1
*
This unit
Chassis
1
) already
*
Bracket Keys
(Included)