Cabinet Construction - Crosley CBES365FS1 Installation Instructions Manual

30" electric slide-in range
Table of Contents

Advertisement

Available languages

Available languages

m
Where local codes DO NOT permit connecting
the
_
Cabinet
Construction
('_'_ _
To eliminate the risk of burns or fire by
"-:-u_reaching over heated surface units, do not have cabinet
appliance-grounding
conductor
to the neutral
(white)
wire, or if connecting
to 4-wire
electrical
system (see Figure 7):
1.
Disconnect the power supply.
2.
Separate the green (or bare copper) and white
appliance cable wires.
3.
In the circuit breaker, fuse box or junction box:
a) Connect the white appliance cable wire to the
neutral (white) wire.
b) Connect the 2 black wires together.
c) Connect the 2 red wires together.
d) Connect the green (or bare copper) grounding
wire to the grounding wire of the circuit breaker,
fuse box or junction box.
Cable from Residence
Green (or Bare
Copper)Wire \ _"_-_____
.
_._
--_/-
White
Wire
Red--'-...J.
_.
////_\_-_
Y
Green (or Bare _[_
x_
_
-_.
I
Copper)
Wire
/_'-_
l_+_+j
,
,, /
_-
___.L//'_/hite
Wire
Junction
_
_U.L.-listedConduit
Box
Connector
(or CSA
Cable from
listed)
Appliance
Figure 7 - 4-Wire Electrical
System
(Example:
Junction
Box)
storage space above the range. If there is cabinet
storage space above range, reduce risk by installing a
range hood that projects horizontally a minimum of 5"
(12.7 cm) beyond the bottom of the cabinet.
C__Countertop
Preparation
The cooktop sides of the range fit over the cutout edge
of your countertop.
If you have a square finish (flat) countertop,
no
countertop
preparation is required. Cooktop sides lay
directly on edge of countertop.
• Formed front-edged
countertops
must have molded
edge shaved flat 3/4" (1.9 cm) from each front corner
of opening (Figure 8).
Tile countertops
may need trim cut back 3/4"(1.9
cm) from each front corner and/or rounded edge
flattened (Figure 8).
Formed
or tile countertop
trimmed
¾" (1.9 cm) back at
front
corners
of countertop
opening.
I
Figure 8
• If the existing
cutout
width
is greater
than
30 1/16"
(76,4
cm),
reduce
the
3A" (1.9
cm)
dimension.
• Countertop
must
be level,
Place a level on the
countertop,
first side to side, then front to back. If the
countertop
is not level, the range will not be level. The
oven must be level for satisfactory
baking
results.
Cooktop
sides of range fit over edges of countertop
@
_
For existing
cutout
width
of 29"
(73.7 cm) (Figure 9):
2 3116"
2 3/16"
(5.56 cm)
-_
(5., _m)
You must also clear 2 3/16"
(5.56 cm) of material
from
front
of countertop.
_A
j
30
_.
(76.2 cm)
31_/2
_
(81 cm)
.....
_--._.
_.
j_ormed
or tile countertop
trimmed
1W'
_
_
(3.2 cm) back at front
corners
of
,,.jV"_
countertop
opening
cm)
figure
_J

Advertisement

Table of Contents
loading

Table of Contents