Table of Contents
Advertisement
Available languages
Available languages
important
Notes
to the
Installer
1.
Read all instructions contained in these installation
instructions before installing range.
2.
Remove all packing material from the oven
compartments before connecting the electrical supply
to the range.
3.
Observe all governing codes and ordinances.
4.
Be sure to leave these instructions with the consumer.
Important
Note
to the
Consumer
Keep these instructions with your owner's guide for future
reference.
IMPORTANT
SAFETY
INSTRUCTIONS
_Cold
temperatures can damage the
electronic control. When using the appliance for the first
time, or when the appliance has not been used for an
extended period of time, be certain the unit has been in
temperatures above 32°F (0°C) for at least 3 hours
before turning on the power to the appliance.
latest edition, or with local codes in United States and
with CAN/CSA-Z240 MH in Canada.
o
o
Make sure the wall coverings
around the range
can withstand
the heat generated
by the range.
Before installing
the range in an area covered
with linoleum or any other synthetic
floor
covering,
make sure the floor covering
can
withstand
heat at least 90°F (32.2°C) above room
temperature
without
shrinking, warping
or
discoloring.
Do not install the range over carpeting
unless you place an insulating pad or sheet of Y4" (0.64
cm) thick plywood between the range and carpeting.
Never leave children
alone or
unattended
in the area where an appliance
is in use.
As children grow, teach them the proper, safe use of all
appliances. Never leave the oven door open when the
range is unattended.
_. !__Stepping,
leaning
or sitting
on the
door
or drawer
of this
range can result in serious
injuries
and can also cause
damage
to the range.
• Be sure your range is installed and grounded
properly
by a qualified
installer or service
technician.
• This range must be electrically
grounded
in
accordance
with
local codes or, in their absence,
with the National
Electrical Code ANSI/NFPA No.
70--latest
edition
in United States or with CSA
Standard
C22.1, Canadian
Electrical Code, Part 1 in
Canada.
The installation of appliances designed for
manufactured (mobile) home installation must conform
with Manufactured Home Construction and Safety
Standard, title 24CFR, part 3280 [Formerly the Federal
Standard for Mobile Home Construction and Safety,
title 24, HUD (part 280)] or when such standard is not
applicable, the Standard for Manufactured
Home
Installation 1982 (Manufactured
Home Sites,
Communities and Setups), ANSI Z225.1/NFPA 501A-
_O
REDUCE
e ALL RANGES
THE RISK OF TIPPING OF
CAN TIR
THE RANGE, THE RANGE
• INJURY TO
MUST BE SECURED BY
PERSONS
COULD
RESULT.
• INSTALL ANTI-
TIP DEVICE
PACKED WITH
RANGE.
PROPERLY INSTALLEDANTI-
TIP BRACKET(S)PROVIDED
WITH THE RANGE. TO
CHECK IFTHE BRACKET(S)
IS INSTALLEDPROPERLY,
GRASP THE TOP REAR
EDGE OF THE RANGE AND
CAREFULLYTILTIT
FORWARDTO MAKE SURE
THE RANGE IS ANCHORED.
• Do not store
items
of interest
to children
in the
cabinets
above
the range.
Children
could be seriously
burned
climbing
on the range to reach items.
• To eliminate
the risk of burns
or fire
by reaching
over
heated
surface
units,
cabinet
storage
space
above
the surface
unit
should
be avoided.
If
cabinet
storage
is to be provided
the risk can be reduce
by installing
a range hood that project
horizontally
a
minimum
of 5 inches beyond
the bottom
of the
cabinet.
• Do not use the oven
as a storage
space.
This
creates a potentially
hazardous
situation.
• Never
use your
range
for warming
or heating
the
room.
Prolonged
use of the range without
adequate
ventilation
can be dangerous.
• Do not store
or use gasoline
or other
flammable
vapors
and liquids
near this or any other
appliance.
Explosions or fires could result.
• Reset all controls
to the "off"
position
after
using
a programmable
timing
operation.
FOR MODELS WITH SELF-CLEAN FEATURE:
Remove broiler pan, food and other utensils
before self-cleaning
the oven. Wipe up excess
spillage. Follow the precleaning instructions in the
Owner's Guide.
Advertisement
Table of Contents
