Page 1
Installation Instructions Renaissance ® Built-in Dishwasher Models RDW24S and RDW241 Part No. 105671 Rev. B...
Page 2
If You Need Help... If you have questions or problems with installation, contact your Dacor ® dealer or the Dacor Customer Service Team. For repairs to Dacor appliances under warranty call the Dacor Distinctive Service line. Whenever you call, have the model and serial number of the appliance ready.
Hazards or Unsafe practices that COULD result in • Always contact the Dacor Customer Service severe personal injury or death.... Team about problems and conditions that you don't understand. See Customer Service Information.
• To prevent household mold and mildew accompanying it. A qualified service technician damage, periodically check the inlet and drain should perform all 0the_service. Contact the hoses for leaks. nearest Dacor authorized service representative for examination, repair or adjustment, _nCO_...
PN: ADWM24H 3Model RDW241 requires installation of either a customer provided, custom overlay door panel or a Dacor glass not modify panel kit (order from your Dacor dealer). loop in hose A custom overlay panel allows you to...
The dishwasher can be connected to a cold or product data label, located inside the right door jamb. hot water supply (maximum 160°F, 70°C). Dacor Grounding Instructions for a Cord- recommends using a hot water supply of 120°F (49°C) to 140°F (60°C). If a cold water supply is...
Page 7
*If installing model RDWH241 in a 24" wide cutout needs to be covered with an edge protector. Call installation of a trim kit (Dacor PN 106925) is required Dacor for the part number of an approved edge to fill the space between the edge of the cutout and protector.
20" (50.8 cm) above the spring kit (Dacor PN 701385). Maximum panel weight bottom of the dishwasher. with heavy duty springs: 23 pounds.
Page 9
Disposer Disposer connection connection _ 4_----Air 2'' dia" max. ,__2" dia. ma i. Keep higher Keep higher than disposer than disposer connection 35" 35" _20"min. connection max. max. Floor Sink trap Disposer Installation without Air Gap Disposer Installation with Air Gap Waste tee 2"...
Verify the Package Contents • Remove all styrofoam and wrap from the plastic dishwasher. Be sure to remove the toe kick from the top of the dishwasher packaging. With the assistance of at least one person, remove the dishwasher from the shipping pallet. Place the unit to the side of the cabinet opening.
Custom Door Panel Installation: continued... Install the Dacor trim kit, PN 106925 (if required), on the dishwasher according to the instructions accompanying Install the two (2) supplied 3/8" screws on the back of the door panel in the locations...
Page 12
Custom Door Panel Installation (cont.): To make small tension adjustments to the spring, hold the back end of the spring with one Open the door slightly and use the six (6) hand and turn the front part one or more times. supplied 1 3/4"...
Page 13
Reattach the front end of the spring by pulling it Measure the height of the front and back of the up and forward to fasten it in the mount. cutout with a tape measure. Adjust the feet, until the front of the dishwasher measures 1/8"...
Page 14
Connect the ground (green) wire on the cable Connecting the Wiring using a loop or spade terminal to the ground Permanently Connected Appliance Only: connection screw located on the dishwasher chassis. enough, If the cord Js not long or if a hard-wire installation is needed, follow the steps below to Junction...
Water Line Connection Installing the Unit in the Cabinet Position the dishwasher in front of the cutout. CAUTION Make sure the drain hose, water supply line and power cable are positioned in the utility cutouts • The unit has a float switch in the base pan and are routed to the side they will be connected.
20" (50.8 cm) above the bottom drain hose. of the dishwasher base. Repeat the Wet Test Checklist. Verifying Operation If the appliance still does not work, contact Dacor Distinctive Service at (877) 337-3226. Do not Pre-verification Check List attempt to repair the appliance yourself.
Final Leveling Attaching the Anti-tip Brackets Check to make sure that adjacent drawers and cupboards can be opened when the dishwasher CAUTION door is open. Reposition the dishwasher Make sure to anchor one anti:tiP bracket 0n each necessary. s de of the d shwasher....
Proper installation is the responsibility the homeowner. The importance of proper installation of your Dacor dishwasher cannot be overemphasized. Has the unit been inspected for cosmetic damage? Adjust the brackets (pull out or push in) until they are flush with the kitchen toe kick on both sides...
Page 19
Item No., 80 933 28 Rev. 02 The Life of the Kitchen? Dacor • 600Anton Blvd. Suite 1000 Costa Mesa, CA 92626 • Phone: (800) 793-0093 • Fax: (626)403-3130 • www.dacor.com...