Led Indicators - Hall Research Technologies Mini-Cat UH1-BT User Manual

Connect the HDMI connector labeled OUTPUT to the sink device (HDTV,

Projector, etc)
 Using a Cat5e or Cat6 cable, connect the RJ45 connectors from the Sender
to the Receiver.
Twisted Pair Cable Recommendations
UH-1BT
UH-1BTX
Note:

If the CATx cable is ran adjacent to or near interfering electrical sources
such as ballasts, generators, motors, etc, then Shielded Twisted Pair (STP)
would be preferred instead of UTP
 Plug in the power supplies at the receiver and at the sender

3. LED Indicators

PWR Power. Indicates unit is powered
ACTIVITY Firmware Running. Blinking means device firmware is running properly
LINK UTP Link. Solid on means Sender & Receiver are communicating
HDCP Video Status. Off = No Video, Blink = Video, Solid ON = Video + HDCP
Mini-Cat® Brand HDMI™ Extender
Figure 3 – Locking HDMI Cable
Distance Cable Type
0 to 199 ft Cat5e, Cat6, Augmented Cat6
200 to 230 ft Cat6, Augmented Cat6
Distance Cable Type
0 to 299 ft Cat5e, Cat6, Augmented Cat6
300 to 330 ft Cat6, Augmented Cat6
Figure 4 – LED Locations
Gauge
24, 23
23
Gauge
24, 23
23
5