Make Sure Range Is Level - Frigidaire FPGF3685LSA Installation Instructions Manual

systems requireno adjustment. W henthe ovenis set
to operate, c urrentwil!flowto the igniter.It will "glow"
similarto a light bulb.Whenthe igniter hasreached
a temperature sufficientto ignitegas,the electrically
controlled o ven valve willopen andflamewillappear a tthe
ovenburner. T hereisa timelapse from30to 60seconds
afterthermostat i sturnedONbeforethe flameappears
at the ovenburner. W henthe ovenreaches the display
setting, t he glowingigniterwill gooff. Theburnerflame
willgo"out"in20to 30seconds a fterigniter goes"OFF".
Tomaintain anygivenoventemperature, this cyclewill
continue aslongasthe display is setto operate.
Afterremoving a ll packing materials a ndliterature from
theoven:
a) Setthe ovento BAKE at300°RSeeUse& Care Guide
for operating instructions.
b) Within60seconds t heovenburner should ignite.
Check for proper f lame(see8.5.2),andallowthe
burner t o cycleonce(seecycleexplanation a bove).
Reset c ontrols t o off.
c) If yourmodel i sequipped witha waist-high b roiler
burner, setovento broil.SeeUse& CareGuide for
operating instructions.
d) Within60seconds t hebroilburner s hould ignite.Check
for proper f lame(see8.5.3).Reset c ontrols t o off.
8.5.2 Oven Burner Flame Adjustment
Llwer
Oven Burner
Baffle
(
1
Figure 8
Waist=High Burner
!i -._Air Shutter
Lower Oven Bottom
_l--Air Shutter (removable)
The approximate oven burner flame length is 1 inch
(distinct inner cone of blue flame).
To determine if the oven burner flame is proper, remove
the oven bottom and burner baffle and set the oven to
bake at 30001: .
To remove the oven bottom, remove oven hold down
screws at rear of oven bottom. Pull up at rear, disengage
front of oven bottom from oven front frame, and pull the
oven bottom out of the oven. Remove burner baffle so
that burner flame can be observed.
[f the flame is yellow, increase air shutter opening size
(see "2" in Figure 9). If the entire flame is blue, reduce
the air shutter opening size.
To adjust flame loosen lock screw (see "3" in Figure 9),
reposition air shutter, and tighten lock screw. Replace
oven bottom.
(_) Lock Scre_
Air Shutter==_!
Figure 9
Oven Burner Tube
i== (_ Orifice Hood
8.5.3 Broil Burner Flame Adjustment
The approximate flame length of the burner is 1 inch
(distinct inner cone of blue flame). To determine if the
broil burner flame is proper, set the oven to broil. If
flame is yellow, increase air shutter opening size (see "2"
in Figure 9 ). If the entire flame is blue, reduce the air
shutter opening size. To adjust, loosen lock screw (see
"3" in Figure 9), reposition air shutter, and tighten lock
screw.
9. Make Sure Range Is Level
Check if the range is level by placing a level horizontally
on an oven rack. Check diagonally from front to back,
then level the range by either adjusting the leveling legs
or by placing shims under the corners of the range as
needed.
When Al! Hookups are Complete
Make sure all controls are left in the OFF position.
Make sure the flow of combustion and ventilation air to
the range is unobstructed.
Model and Serial Number Location
The serial plate is located on the oven front frame
behind the drawer.
When ordering parts for or making inquiries about
your range, always be sure to include the model and
serial numbers and a lot number or letter from the
serial plate on your range.
Your serial plate also tells you the rating of the
burners, the type of fuel and the pressure the range
was adjusted for when it left the factory.
Before You Call for Service
Read the Before You Call for Service Checklist and
operating instructions in your Use and (::are Guide.
It may save you time and expense. The list includes
common occurrences that are not the result of
defective workmanship or materials in this appliance.
Refer to the warranty in your Use and (::are Guide for
our service phone number and address. Please call or
write if you have inquiries about your product and/or
need to order parts.
6