INSTALLATION
AND SERVICE
MUST BE
PERFORMED
BY A QUALIFIED
INSTALLER.
IMPORTANT:
SAVE FOR LOCAL
ELECTRICAL
INSPECTOR'S
USE. READ AND SAVE THESE
INSTRUCTIONS
FOR FUTURE
REFERENCE.
• ALL RANGES
CAN TiP
• INJURYTO
PERSONS
COULD
RESULT
• iNSTALL
ANTI=TIP
DEVICE
PACKED
WiTH
RANGE
• SEE iNSTALLATiON
INSTRUCTIONS
if the
information
in this
manual
is not followed
exactly,
a fire or
explosion
may result
causing
property
damage,
personal
injury or death.
FOR YOUR SAFETY:
m
Do not store or use gasoline
or other
flammable
vapors
and liquids in the
vicinityofthis
oranyotherappliance.
WHAT TO DO iF YOU SMELL
GAS:
= Do not try to light any appliance.
= Do not touch
any electrical
switch;
do
not
use
any
phone
in your
building.
= immediately
call your
gas supplier
from
a neighbor's
phone.
Follow
the gas supplier's
instructions.
= if you
cannot
reach
your
gas
supplier,
call the fire department.
installation
and
service
must
be
performed
by a qualified
installer,
service
agency
or the gas supplier.
Provide
proper fuel type
Before proceeding: Your range is factory preset to
operate on natural gas. If L.P. conversion is needed,
contact your local L.P. Gas provider for assistance.
The L.P. conversion kit may be located on the lower rear
back panel of the range. If no L.P. kit is provided, contact
your product dealer to obtain the correct L.P. conversion kit.
__
Refer to your serial plate
for applicable agency
certifications
important
notes to the installer
•
Read all instructions contained in these installation
instructions before installing range.
•
Remove all packing material from the oven
compartments
before connecting the gas and
electrical supply to the range.
•
Observe all governing codes and ordinances.
•
Be sure to leave these instructions with the consumer.
important
notes to the consumer
•
Keep these instructions with your Use & Care Guide
for future reference.
•
Be sure your range is installed and grounded properly
by a qualified installer or service technician.
Special instructions for appliances installed in the State of
Massachusetts:
This appliance can only be installed in the State of
Massachusetts by a Massachusetts licensed plumber or
gas fitter. When using a flexible gas connector, it must not
exceed 3 feet (36 inches) in length. A "T" handle type
manual gas valve must be installed in the gas supply line to
this appliance.
IMPORTANT
SAFETY INSTRUCTIONS
Installation of this range must conform with local codes or,
in the absence of local codes, with the National Fuel Gas
Code ANSI Z223. l--latest
edition when installed in the
United States.
When installed in a manufactured (mobile) home,
installation must conform with the Manufactured Home
Construction and Safety Standard, Title 24 CFR, Part 3280
[formerly the Federal Standard for Mobile Home
Construction and Safety, Title 24, HUD (Part 280)] or, when
such standard is not applicable, the Standard for
Manufactured Home Installations, ANSI/NCSBCS A225.1,
or with local codes.
This range has been design certified by CSA International.
As with any appliance using gas and generating heat, there
are certain safety precautions you should follow. You will
find them in the Use & Care Guide, read it carefully.
p/n 316903000 (1004)
1