Operation - Frigidaire FGF379WECR Installation Instructions Manual

Operation of Surface Burners
This range is equipped with sealed burners as shown
below.
Burner Cap
Locating Tabs
Trim Ring (some models)
or Burner Pan (some models)
6. Installation of Burner Cap Assembly
Your range may be equipped with either trim rings or
burner pans, or trim rings and burner pans. Install pans
(some models) and trim rings (some models) as follows:
Grate @
Burner
J Cap
Trim Ring
_ed)
Burner Pan
(if equipped)
€,
@
@
®
Burner Base
Cooktop
Surface
7. Electric Ignition Surface Burners
Operation of electric igniters should be checked after range
and supply line connectors have been carefully checked for
leaks and range has been connected to electric power. The
surface burner gas valves have detent positions in both the
Off and LITE positions. The knob must be pushed in to
rotate the knob past these detent positions.
a. To check for proper lighting, push in and turn a
surface burner knob to the LITE position. You will hear
the igniter sparking.
b. The surface burner should light when gas is available to
the top burner. Purge air from supply lines by leaving
knob in the LITE position until burner ignites. Each
burner should light within four (4) seconds in normal
operation after air has been purged from supply lines.
c. Visually check that burner has lit. Once the burner
lights, the control knob should be pushed in and
turned out of the LITE position.
d. There are separate electrodes (igniters) for each burner.
Try each knob separately until all burner valves have
been checked.
Note: Knob styles may vary from those pictured below.
Knob Used Knob Used
withTwo withkinear
PositionValve FlowValve
8. Adjust the "LOW" Setting of Surface Burner
Valve (Linear Flow Valves Only)"
Test
a.
b.
C.
d.
e.
TO
Surface
Burner k_
to verify if "LOW" setting should be adjusted
Push in and turn control to kITE until burner ignites.
Push in and quickly turn knob to LOWEST POSMON.
If burner goes out, reset control to OFF.
Remove the surface burner control knob.
Insert a thin-bladed screwdriver into the hollow valve
stem and engage the slotted screw inside. Flame size
can be increased or decreased with the turn of the
screw. Turn counterclockwise to increase flame size.
Turn clockwise to decrease flame size.
Adjust flame until you can quickly turn knob from LITE to
LOWEST POSITION without extinguishing the flame. Flame
should be as small as possible without going out.
Note: Air mixture adjustment is not required on surface
burners.