Advertisement
Available languages
Available languages
8.
Turn the outer door assembly a half turn (180 °)
and replace the outer
door assembly
over the
lower
door assembly.
Replace the nylon slide
under the handle (thin side facing inward) on the
same side of the ball screw. Replace the 2 screws
under the door and the 3 screws on top of the
door.
9.
Turn the door so the external panel faces the work
table. Interchange
the position
of the latch pin
with the latch pin cap on the opposite end of the
door.
NOTE: The latch pin is to one side of its mounting
holes
and
its position
on the
door
is very
important.
Improper
mounting
may damage the
porcelain finish on the oven frame when closing
the door. The latch pin must be on the right side
of the mounting screws on a left-hand
door, and
on the left side of the mounting screws on a right-
hand door.
10. Remove the lower hinge on the left side of the
oven frame.
Save for reassembly later.
Latch
'0
Latch
Pin
,,- I
Pin
O,_
OI-
L.H.
_i. _
R.H.
DOOR
DOOR
Figure 9
11 Relocate
the 3 right
side upper dummy
hinge
screws toward
the lower
left side of the oven
frame.
12 Replace the threaded pin (removed in step 2) onto
the hinge
that was removed
in step
10, and
replace the hinge assembly at the upper right end
of the oven frame.
13 Remove the adjustable door support at the lower
right side of the oven frame and move to the left
side of the frame (with 1 retainer screw).
14. Remove the upper left side hinge from the oven
frame,
then remove the threaded
pin from the
hinge. Save the threaded pin for reassembly later.
15. Relocate the 3 dummy
hinge screws from the
lower right
side of the oven frame toward
the
upper left side of the oven frame.
16. Replace the hinge removed in step 14 toward the
lower right side of the oven frame.
17. Put the washer (removed in step 3) on the hinge's
counterbore made for this purpose.
18. Move the oven light switch to the left side of the
oven frame:
a)
Grab the switch plunger and gently pull out from its
location. Use the small, flat-head screw driver.
b)
Unplug the switch from the terminal connector and
push the door switch terminal and wire assembly
inside the oven frame.
c)
Remove the switch plug on the left side of the oven
frame. Use the flat-blade screw driver if necessary.
Replacethe switch plug on the right side of the oven
frame.
d)
Use long nose pliers to grab and pull out the door
switch terminal connector and wire assembly from
the hole on the left side of the frame.
e)
Connect the door switch to the terminal connector.
f)
Push the oven light switch into the new hole in the
oven frame.
19. Replace the door. First engage the sleeve in the
upper end of the door over the upper hinge pin.
Lift the door and slide over the lower
hinge.
(Ensure the washer stays in place.)
20. Gently close the door while ensuring it will stay in
place on the lower hinge. Replace the lower hinge
threaded pin saved in step 14 into the lower hinge.
21. Replace the lower moulding.
Plug-Oven
Light Switch
Self-Cleaninc
Oven Lid
Latch
Door
Seal
Gasket
Door
Handle
ustable
Door
Support
1
Nylon Slide--_
Screw
Figure 10 - RIGHT HAND DOOR
6
Advertisement
