Installation - Frigidaire FEB398WECC Installation Instructions Manual

Cable from Power Supply
_Black
Ground Wir Wires
Red
7
_ Junction Box
J \White Wire
Ground Wire U.L.-Listed Conduit
(Bare or Green Connector (or CSA listed)
Cable from appliance
Figure 5
3-WIRE GROUNDED JUNCTION BOX
Improper connection of aluminum
house wiring to copper leads can result in a short
circuit or fire. Use only connectors designed for
joining copper to aluminum, and follow the
manufacturer's recommended procedure closely.
,
If used in mobile homes or if local codes DO
NOT permit connection of the frame grounding
conductor to the neutral (white) wire, separate
the white and bare copper ground wires that extend
out of the end of the supply cable of the appliance.
Connect the white wire from supply cable to the
neutral white wire in the junction box. Connect the
black and red wires from the supply cable to the
matching color wires in the junction box. The bare
wire must now be used to ground the appliance in
accordance with local electrical codes. Connect the
bare copper ground wire to the grounded lead in the
service panel. DO NOT ground to a gas supply pipe.
DO NOT connect to electrical power supply until
appliance is permanently grounded. Connect the
ground wire before turning on the power (figure 6).
Cable from Power Supply
U.L-Listed Conduit
Connector (or CSA listed)
Cable from appliance
Figure 6
4-WIRE GROUNDED JUNCTION BOX
If connecting to a 4-wire electrical
system (mobile homes), the appliance frame MUST
NOT be connected to the neutral wire of the 4-wire
electrical system.
NOTE TO ELECTRICIAN: The armored cable leads
supplied with the appliance are CSA-recognized for
connection to larger gauge household wiring. The
insulation of the leads is rated at temperatures much
higher than temperature rating of household wiring. The
current carrying capacity of the conductor is governed by
the temperature rating of the insulation around the wire,
rather than the wire gauge alone.
Do not lift the oven by the door handle.
5. Cabinet Installation
A. 24" and 27", Single and Double Ovens
Insert appliance into cutout. Use the screws provided
to fasten the front frame of the appliance to the
cabinet. The mounting holes in the front frame of
appliance may be used as a template to locate the
appliance mounting screw holes.
To fasten the appliance to the cabinet:
1. Line up the 2 mounting holes on the decorative
trim (ventilation) (taped to the oven side panel)
with the lower mounting holes on each side of the
oven frame, below the oven door (see figure 7).
2. Use 2 screws from the miscellaneous parts bag to
secure the decorative trim (ventilation) and
appliance to the cabinetry.
3. Use the remaining 2 screws for mounting the
appliance in the upper two mounting holes on
each side of the oven frame, above the door.
MOUNTING
REW
DECORATIVE TRIM
)
/
MOUNTING
SCREW
Figure 7