Table of Contents
Advertisement
INSTALLATION
WARNING!
Refer to Safety chapters.
Gas connection
The gas supply ramp is on the back of the
oven.
1. Before the gas connection, disconnect
the oven from the mains.
2. Close the primary valve of the gas
supply.
3. Do not fully put the oven into the built-in
cabinet, leave approximately 30 cm
gap.
4. Connect gas supply.
B
A. End of shaft with nut
B. Washer
C. Elbow
D. Rubber pipe holder for liquid gas
5. Put the supplied gasket between the
pipe and the gas supply ramp. Turn the
pipe to the 1/2" gas supply ramp.
6. Use a 22 mm spanner to tighten the
nuts. Keep the gas supply ramp in the
correct position. Gently handle the gas
supply circuit.
WARNING!
Do not use flame to check for leaks.
7. Fully move the oven into the built-in
cabinet.
8
WARNING!
Do not squeeze the gas supply ramp
and the pipe when you move the oven
into the built-in cabinet.
8. Seal the connection correctly. Use a
leak detection to control it.
Use the rubber pipe holder for liquid gas.
Always engage the gasket. Then continue
with the gas connection.
If one or more defects are visible, do not
repair the pipe, but replace it.
When installation is complete, make sure
that the seal of each pipe fitting is correct.
Use a soapy solution, not flame.
BEFORE THE APPLICATION CHECK IF
THE FLEXIBLE PIPE:
A
Is at the room temperature.
Is no longer than 1500 mm.
C
Has no throttles.
Is not subject to traction or torsion.
Does not touch sharp edges or corners.
D
It is easily accessible.
REGULARLY CONTROL THE FLEXIBLE
PIPE. CHECK IF:
It is not cracked, cut, burnt on the two
ends and on its full length.
It is not hardened, it should be elastic.
The fastening clamps are not rusted.
Expiration term is not due.
Minimum level adjustment of
the oven burner
1. Disconnect the oven from the mains.
2. Turn the knob for the gas control to the
minimum position and remove it.
3. Adjust the adjustment screw (A) with a
thin-bladed screwdriver.
Advertisement
Table of Contents
