Frigidaire FEB398WECC Installation Instructions Manual page 6

B. 30", Single and Double Ovens
Thewall ovencantip when the
door is open.Theanti-tip brackets
suppliedwith the wall oven mustbeattachedto
the cabinetandthe applianceto preventtipping
of the wall ovenand injury to persons.
Anti-Tip Brackets InstallationInstructions
1. Unpack the wall oven and find the 2 anti-tip
screws included in the literature package. The
door may be removed to facilitate handling (see
the Owner's Guide for instructions).
.
The anti-tip brackets are temporarily installed under
the decorative side trims of the oven when shipped
(see Figure 8 or 9 ). Remove the anti-tip brackets
from the unit side frame using a No. 2 Robertson®
screw driver (square drive preferred, however a No. 2
Phillips® or Quadrex® screw driver can also be
used). Open the door to remove the screws, located
at the upper end of the side trim.
.
Insert the unit into the cabinet opening. Slide unit
inward leaving 1 3/8" (3.5 cm) clearance between
the oven decorative trim and cabinet. Pull the
armored cable through the hole in the floor and
toward the junction box while moving the appliance
inward. Use the second set of holes in the side frame
of the unit as a guide to find the position of the anti-
tip brackets on the sides of the cabinet opening.
Mark the position of the anti-tip brackets as shown in
Figure 8 or 9.
Cutout Dimensions
28 1/2" (72.4 cm) Min.*
4 29" (73.7 cm) Max.*
I
I 28 1/16" (71.3 cm)Min. I
lid I
29 5/8" (7/5.2cm) Max. I_h
i -fT /
i | 122 A nti-TiP Brackets
21 1/4" I
(154.0
cm)
/
.--_-4_
1!_.' Wood Shims(if Needed)J
* RecommendedCutout Width is 28 1/2" (72.4 cm)
Figure 8
30" SINGLE OVEN
27 1/4"
(71.8 cm) Min.
28 7/8"
(73.3 cm) Max.
Cutout Dimensions
28 1/2" (72.4 cm) Min.*
29" (73.7 cm) Max.*
r
I
I i1298 1/16" <71.3 cm)Min.ii N
I 7/16" (74.8 cm) Max.
D' /
' I
Anti-Tip Brackets
42 3/4"
(108.6 cm)
42
(106.7 cm)
1,
* Recommended Cutout Width is 28 1/2" (72.4 cm)
Figure 9
30" DOUBLE OVENS
49 1/8"
(124.8 cm) Min.
49 3/4"
11(126.4cm) Max.
.
Pull out the oven approximately 1 foot (30.5 cm)
away from the cabinet. Reposition each bracket on
the cabinet and drill 1/8" pilot holes. Fasten the
brackets in place using the 2 screws supplied (#10 x
1 I/4"
long).
If needed, add wood spacers at the anti-tip bracket
locations to reduce the cabinet opening to 28 I/2"
(72.4 cm).
Now push the unit in and against the cabinet, then
attach the unit to the anti-tip brackets using the 2
screws removed earlier from the side frame.
6