Important Instructions - Frigidaire FEB398WECC Installation Instructions Manual

24", 30" electric wall oven
Hide thumbs Also See for FEB398WECC:
Table of Contents

Advertisement

Available languages

Available languages

Important
Notes
to the Installer
1.
Read all instructions contained in these installation
instructions before installing the wall oven.
2.
Remove all packing material from the oven
compartments before connecting the electrical supply
to the wall oven.
3.
Observe all governing codes and ordinances.
4.
Be sure to leave these instructions with the consumer.
5.
Oven door may be removed to facilitate installation.
6.
THESE OVENS ARE NOT APPROVED FOR
STACKABLEOR SIDE-BY-SIDE INSTALLATION.
Important
Note
to the Consumer
Keep these instructions with your Owner's Guide for future
reference.
Observe all governing
codes and local ordinances
1.
A 3-wire or 4-wire single phase 120/208 or 120/240
Volt, 60 Hz AC only electrical supply is required on
a separate circuit fused on both sides of the line
(time-delay fuse or circuit breaker is recommended).
DO NOT fuse neutral. The fuse size must not exceed
the circuit rating of the appliance specified on the
nameplate.
NOTE: Wire sizes and connections must conform with
the fuse size and rating of the appliance in accordance
with the American National Electrical Code ANSI/NFPA
No. 70-latest edition, or with Canadian CSA Standard
C22.1, Canadian Electrical Code, Part 1, and local codes
and ordinances.
IMPORTANT
SAFETY
INSTRUCTIONS
An extension
cord should
not be used
with
this appliance.
Such use may result in a fire,
electrical
shock,
or other
personal
injury.
• Be sure your wall oven is installed
and grounded
properly
by a qualified
installer
or service
technician.
• This wall oven must be electrically
grounded
in
accordance
with
local codes or, in their
absence,
with the National
Electrical
Code ANSI/NFPA
No.70-
latest edition
in United
States,
or with
CSA
Standard
C22.1, Canadian
Electrical
Code, Part 1, in
Canada.
Stepping,
leaning
or sitting
on the
door of this wall oven can result in serious
injuries
and can also cause damage
to the wall
oven.
• Never use your wall oven for warming or heating
the room. Prolonged use of the wall oven without
adequate ventilation can be dangerous.
The electrical
power
to the oven must
be shut off while
line connections
are being
made.
Failure
to do so could
result
in serious
injury
or
death.
1.Carpentry
Refer to figure 1 or 2 for the dimensions applicable to
your appliance, and the space necessary to receive the
oven. The oven support surface may be solid plywood or
similar material, however the surface must be level from
side to side and front to rear.
2. Electrical
Requirements
Theses appliances must be supplied with the proper
voltage and frequency, and connected to an individual,
properly grounded branch circuit, protected by a circuit
breaker or fuse, having amperage as noted on the rating
plate (the rating plate is located on the oven frame).
2.
These appliances should be connected to the fused
disconnect (or circuit breaker) box through flexible
armored or nonmetallic sheathed cable. The flexible
armored cable extending from the appliance should
be connected directly to the junction box. The
junction box should be located as shown in figure 1
or 2 with as much slack as possible remaining in the
cable between the box and the appliance, so it can
be moved if servicing is ever necessary.
3.
A suitable strain relief must be provided to attach
the flexible armored cable to the junction box.
Electrical
Shock
Hazard
• Electrical ground is required on this appliance.
• Do not connect to the electrical
supply until
appliance is permanently
grounded.
• Disconnect
power to the junction
box before
making the electrical connection.
• This
appliance
must
be connected
to
a
grounded,
metallic, permanent
wiring system,
or a grounding
connector should be connected
to the grounding
terminal
or wire lead on the
appliance.
• Do not use a gas supply line for grounding
the
appliance.
Failure to do any of the above could result in a
fire, personal injury
or electrical shock.
3

Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents