Frigidaire FMV156DBA Installation Instructions Manual

Over the range

Advertisement

m
m
BEFORE YOU 8EGmN
Roadthe.o,',.,r,,c.o,,.com ,tetely.r,
dcoror,,.y.
® _IPOR'rANT-
Save these instructions for
local inspector's use.
® _MPOR"rANT-
Observe all governing codes
and coordinates.
. Note to installer-
Be
sure to
leave these
instructions with the Consumer.
. Note to Consumer-
Keep these instruc-
tions for future reference.
. Skitl LeveJ
- Installation of this appliance
requires basic mechanical and electrical skills.
Proper installation is the responsibility of the instailer.
Product failure due to improper installation
is not cov-
ered under the Warranty.
Please read atI instructions
thoroughly before installing
the Over the Range Microwave Oven. Two people are
recommended
to install this product.
If a new electrical
outlet
is required,
its installation
should be completed
by a qualified electrician before
the Microwave Oven is installed. See 3 ELECTRICAL
GROUNDING
INSTRUCTIONS
on page 2.
UNPACKING
AND EXAMINING
YOUR OVEN
Open the bottom of the carton, bend the carton flaps back and
tilt the oven over to rest on plastic foam pad. Lift carton off oven
and remove all packing
materials, WALL and TOP CABINET
TEMPLATE,
Turntable,
and Turntable
Support.
SAVE
THE
CARTON AS IT MAY MAKE INSTALLATION
EASIER.
1. Remove the feature sticker from the outside of the door, if
there is one.
2. DO NOT REMOVE THE WAVEGUIDE
COVER, which is
located on the right side wall of the oven cavity. Check to
see that there is a Wall TEMPLATE
and Top CABINET
Template. Read enclosures and SAVE the Operation
Manual.
Check the oven for any damage, such as misaligned or bent
door, damaged
door seals and sealing surfaces,
broken
or
loose door hinges and Iatches and dents inside the cavity or on
the door. If there is any damage, do not operate the oven and
contact your dealer
or ELECTROLUX
AUTHORIZED
SER-
VICER. See installation instructions for more details.
Oven Cavity
Hinges
Safetydoor
Doorseals and
latches
sealing surfaces
NEED HELP?
For customers in the United States, call: 1-800-944-9044
For customers in Canada, caII: 1-800-213-9397
(Engiish)
1-800-668-4606
ext.8199 (French)
READ CAREFULLY,
KEEP THESE INSTRUCTIONS,
P/N316137336
TINSEB386MRR0

Advertisement

Table of Contents
loading

Summary of Contents for Frigidaire FMV156DBA

  • Page 1 BEFORE YOU 8EGmN Roadthe.o,',.,r,,c.o,,.com ,tetely.r, dcoror,,.y. ® _IPOR'rANT- Save these instructions for Proper installation is the responsibility of the instailer. local inspector's use. Product failure due to improper installation is not cov- ® _MPOR"rANT- Observe all governing codes ered under the Warranty. and coordinates.
  • Page 2: Wall Construction

    mnsta ation 1 MOUNTING SPACE 3 ELECTRICAL GROUNDmNG This Microwave Oven/Hood requires a mounting space on a wall as shown in Figure 1. It is designed to be used with stan- This appliance must be grounded. This oven is equipped with a dard 12-inch wail cabinets.
  • Page 3: Hood Exhaust

    mnsta ation 4 HOOD EXHAUST DUCT 5 TOOLS RECOMMENDED When the hood is vented to the outside, a hood exhaust duct is required. AII ductwork must be metaI; absolutely do not use pIastic duct. Check that all connections are made securely. Phillips Screwdriver •...
  • Page 4: Preparation Of The Oven

    mnstallation 7 PREPARATION OF THE OVEN 1. Turn oven on the side. See Figure 5. 2. Follow steps (A)-(D) to remove mounting plate from the back of the oven as shown in Figure 5. Release mounting plate by pulling out the lever that is on the bottom of the oven.
  • Page 5: Oven Installation

    mnsta ation 8 VENTiLATiON SYSTEM (PREPARING OVEN FOR iNSTALLATiON) (C) VERTICAL EXHAUST: OUTSIDE VENTiLATiON 1. Remove and save 2 screws from back edge and 3 screws from the top center of the Fan Cover Bracket. Remove Fan Cover Bracket by sliding it in the opposite direction of the arrow on the Fan Cover Bracket as shown in Figure 11.
  • Page 6: Microwave Oven

    mnsta ation 9 OVEN iNSTALLATiON cont. MOUNTING PLATE 1_ Separate 4 Toggle BoIts _, packed in the INSTALLATION HARDWARE, from the Toggle Nuts. ¢= 2_ Match 5/8" holes (not in studs), drilled through WALL TEM- PLATE into wail to corresponding holes on Mounting Plate.
  • Page 7 mnsta ation Figure 21 Figure 22 11MOUNTING OVEN TO THE people are recommended to attach Microwave Oven/Hood to the Mounting Plate. 1. Thread the Power Supply Cord through the hole made in the bottom of the top cabinet. InstalI the oven by snapping it onto the Mounting Plate.
  • Page 8 mnsta_ation...

This manual is also suitable for:

Fmv156dsaFmv156dcaFmv156dqaCfmv156fmcCfmv156dbeCfmv156dcf ... Show all

Table of Contents