Adjusting The Door Springs - GE ZBD9900R00II Installation Instructions Manual

Installation Custom Panel
Custom Door Panel Dimensions
Your new Monogram dishwasher can be installed with a fully
integrated, buyer supplied custom door panel or Hongram
accessory panel that extends from the toe kick to the counter
top. The unit comes with everything needed to make installing
the door panel easy.
The custom panel should be a minimum of 3/4" (!9mm) thick.
Items provided with the unit
Two 3/8" screws (B)for temporarily hanging the panel.
Six 1-3/4" screws (D) for mounting the custom wooden panel
to the dishwasher.
Custom Panel Dimensions
Up to 15 Ibs, with unit
wtnt'"eg": 15-19 Ibs. Order 1X
WD01X10445
19-23 Ibs. Order 2X
WD01X10445
For dimensional information see pages 3 and 4.
INSTALLING THE CUSTOM PANEL
OR MONOGRAM ACCESSORY
PANEL
A custom door panel should be installed before the unit is
mounted to the cabinet.
Refer to the illustration at the right for instruction references.
1. Fit the handle (A) onto the panel according to the manu-
facturer's instructions. (NOTE:A handle should be used rather
than a knob, because a knob does not provide enough grip.)
IMPORTANT!The custom panel must not IJ
obstruct the fan exhaust vent; otherwise,
L
moisture from the vent could eventually
damage the cabinet and create drying
problems. Ea
2. The two short screws (B) go into the back
of the panel 15-7/16" (392 mm) from the upper edge of the
panel and 10-7/8" (266 mm) from the center of the panel.
Insert the short screws into the panel, leaving 1/8" (3 mm) of
space between the screw head and the panel.
3. Hook the panel screws (B)into the keyholes (C)on the dish-
washer door.
4. Slide the panel to the left until it is centered in the opening
and secure the screws.
5. Open the door and use the six screws (D)supplied to secure
the panel to the door.
6. Exhaust vent can be adjusted by loosening vent screws on
the side of the door and moving the exhaust vent up or down.
Note: If vent is pulled downward too far it will seperate from
the exhaust conduit and must be reattached.
NOTE:If the door panel weighs more than !5 pounds, you
may need to order the heavy-duty door springs (Order Kit #
WD01X10445).
Max panel width cannot exceed cutout dimensions less 1/8"
(2.Smm) reveal on each side.
B
ADJUSTING THE DOOR SPRINGS
Before you push the dishwasher into the cabinet opening, test
the door to make sure it stays in place at any angle. If it tends
to fall down, pull out the machine and adjust the tension of the
door springs on the sides of the machine by moving them one
hole farther back or by twisting the spring to make it shorter.
en