Recirculating; General Information Attach Mounting Plate To Wall; Preparation Of Top Cabinet - GE JVM1490 Installation Instructions Manual

Installation Instructions
RECIRCULATING
{Non-Vented Ductless)
INSTALLATION OVERVIEW
C1. At:ach Mounting Plate to Wall
C2. Prepare Top Cabinet
C3. Adjust Blower
CA. Mount the Oven
C5. Insudl Charcoal Filter
[_ ATTACH THE MOUNTING
PLATE TO THE WALL
Attach the plate m the wtdl using toggle bolts. At
least one wood screw must be used to attach the
plate to a wall stud.
[]Remove the toggle win_ Dora the bolts.
[nsert the bolts into the nlountin ' la_ throu 'h
[] gP g
the holes designated to go into d*)wldl and
reattach the toggle wings m _A _'onto each bolt.
To use toggle bolts:
SpacflLa forTuggles
MoreThan W_fll
4_Thickness
%ggleWin£s
Mounting i -/Toggl'e
m t,qr_Wall , P i
BollEnd
[] Place 1he mounting plate against the wall m_d
insert the toggle wings into (he holes in the wall
to mount the plate.
NOTE: Betbre tightening toggle bolls and wood
screw, make sure 1he tabs on the mounting plato
much the bottom of the cabinet when pushed flush
agtdnst the wall and that the plate is properly
centered under the cabinet.
CAL_TION: Be carefuI to avoid pinching fingers
between the back of' the mortaring plate and the wtdL
[] Tighten all bolts. Pull the plate away ti:om (he w_dl
to help tighten the boils.
USE TOP CABINET TEMPLATE
FOR PREPARATION OF TOP
CABINET
_,_u need to drill holes [br the top support screws and
a hole large enough fbr the power cord to fit (hrough.
_=========_
• Read the instructions on the TOP CABINET
TEMPLATE.
• Tape it underneath the mp cabinet.
• Drill ttm holes, tbllo_ng the instructions on the
TOP CABINET "rEMPIJ\TE.
CAIYrION: Wear safer) goggles when drilling holes
in the c_-ff_inetbottom.
19