GE CVM2072 Installation Instructions Manual page 17

Installation Instructions
ADAPTING MICROWAVE
BLOWER FOR OUTSIDE
BACK EXHAUST (cont.)
_Roll the blower unit 90 ° st) that tim blade
openings are facing the fl'ont of the microwave.
BeforeRolling After Rolling
Microwave
_ Gently the wire the between the
slip
through gap
two tabs on the top of the blower so the wire is
behind the tabs,
Microwave
BeforeRerouting After Rerouting
_] Rotate blower trait com_terclockwise 180 °.
BeforeRotation
Microwave
After Rotation
Microwave
_ Place the blower unit back into the I)ening,.
o
End
CAUTION: Do not pull or stretch the blower refit
wiring. Make sure the wires are not pinched.
NOTE: The blower unit exhaust
openings should match exhaust openings
on
rear of
microwave oven.
] Guide the wire down into the blower o )ening
} ,
st) it rests secm'e]} in front of the blower.
] Secure the blower trait to the microwaxe with
the screw from Step 1,
BlowerPlate
' Backof
Microwave
_sBIc;:er M°t°r
_ Replace the bh)x_er in the plate position
s_ln/e
as before with the screw.
_ Attach the exhaust the of the
_t d;lpt()l"
to
l'e_ll"
oxen b) sliding it into the guides at the top
center of the back of the oxen.
Adaptor
_L Backof
_Micli°dla ve
iGuide
17