GE Monogram ZDP48N4G Installation Instructions Manual page 12

Installation
Pro/essional Ranges
Connect
Electrical
Plug power cord into properly grounded
receptacle.
st° 7
Slide the
Range
Into
Position
• Carefully, slide the range into position.
-Be careful not to entange power cord and
gas flexible tubing.
• Be sure the right rear leg is engaged in the
slot of the installed anti-tip bracket.
• Check for proper installation by grasping the
range at the top fi'ont edge and carefully
attempt to tilt the range forward.
• Check to be sure the fi'ont of the range is
level. Adjust front leveling legs accordingly.
• Replace the fi'ont kick panel by reversing the
proceedure described in Step 1.
Replace
Oven Door(s)
To replace the oven doors:
• Slide the hinges into the openings. The
hinge should rest in the center of each
hinge roller.
• Open the door fully and unlock hinge
latches.
CAUTION: Take care when replacing the
oven doors. If the hinge latch is not securely
locked, the hinge may snap back and sepa-
rate. If the hinge separates, you must apply
pressure (possibly with your foot) to press it
back together and then engage the brass
hinge latch.
DoorHingeRoller
-Lock
(Closed)
-Un-Lock
12