Hardware Installation - Planet IVS-110 User Manual

Back Panel
Audio-in Jack Audio-in (line level) jack allows any device that could input audio.
Reset Button This button is hidden in the pinhole. Please refer to the Appendix A in manual
for more information.
Status LED The Status LED will turn green while system is booting up successfully. This
LED is also used to indicate the status of network connection. The LED will
flash green while some on access the IVS-110.
Audio-Out Jack Audio-out Jack allows this device to output audio or alerting sound.
12V DC-in Jack The input power is 12V DC.
NOTE: Only use the power adapter supplied with IVS-110. Otherwise, the
product may be damaged.

2.3 Hardware Installation

1. Attach video source to IVS-110
To use IVS-110, user must supply video source to IVS-110. Connect the BNC terminal of
camera to the IVS-110's video input and make sure to power on camera first.
2. Attach Audio source to IVS-110 (option)
If user needs not only video stream but also audio stream, then the audio source should be
attached to IVS-110. Connect the RCA terminal of audio device's line output to the IVS-110's
RCA input and make sure to power on your camera or audio device first.
3. Plug an Ethernet cable into IVS-110
Connect an Ethernet cable to the LAN socket located on the IVS-110's panel and attach it to
the network. If there has a PoE switch in your network, you can connect the IVS-110 LAN
cable to this PoE switch to obtain power. The power adapter is unnecessary when IVS-110 is
connected to a PoE switch.
4. Connect RS-485 (option)
When users would like to apply a camera with P/T/Z function, they usually need to connect
their communication port (for camera control) through RS-485. After RS-485 was correctly
connected to D+ and D-, the remote users could control the camera movement through
internet.
9