Required Items Not Included; Required Tools; Rack-Mounting The Console Switch; Performing A Standard-Mount Installation - HP Server Console Switch G2 User Manual

Required items not included

•
Interface adapters
One interface adapter is needed for each server or device.
USB
o
PS2
o
Serial
o
HP BladeSystem
o
•
UTP CAT 5 or better cable
•
Cage nuts and M6 screws (included with your original rack hardware kit)

Required tools

The following tools are required for some procedures:
•
Phillips screwdriver
•
Cage nut insertion tool (included with your original rack hardware kit)

Rack-mounting the console switch

WARNING:
console switch with I/O connectors and the AC power inlet, facing downward (facing the floor).
Before installing the console switch into the rack, connect the console switch to a power source using the
1.
power cords provided.
An activity indicator light is displayed after a few seconds. If the activity indicator light does not display,
be sure that the power cord is connected, and the power source is valid.
Choose one of the following configurations:
2.
Standard-mount
o
Cantilever-mount
o
Side-mount
o

Performing a standard-mount installation

Remove the six screws, three on each side, from the console switch.
1.
("Installing the interface
For safe use, do not mount this product with the rear panel, which is the side of the
adapter" on page 23)
Installing the console switch 15