System Components - Minicom Smart User Manual

Smart ip extender
Table of Contents

Advertisement

Internal Reset/Power Option - This option applies to remote systems where no
IPMI Version 1.5 is available. The optional bracket is mounted in a free PCI/AGP
slot. Main board pins for reset and power on/off have to be connected to the bracket.
With this option it is possible to perform a remote reset, power cycle, and power
on/off.
External Power Switch Option - When there is neither a IPMI V1.5 option
available or the ability to place a bracket in the remote system, an external power
switch box can switch the power on and off.
IPMI Version 1.5 - defines a serial connection to access certain system parameters
and perform system actions like powering down or a hard reset. Modern server
systems, supporting the IPMI V1.5 specification, provide a mode where the
externally available COM2 serial connection can be configured as a system
management port (sometimes called an emergency management port). IP Extender
may use this port in order to enable remote system management operations.

5. System components

1 IP Extender Extender box
Cables (illustrated below)
Power cord
Marketing & Documentation CD
Optional IPMI Option. This is a serial cable for connecting the IP Extender
and an IPMI V1.5 compliant serial management port on the remote system.
Optional Internal Reset/Power Option. The internal reset/power option (see
Figure 2.2) consists of a PC bracket with a Sub-D 9 jack on the outside and
4x2 pin connector in the inner side. The Sub-D 9 jack is connected to the IP
Extender Serial Port 2. The internal 4x2 pin connector allows to connect the
reset and power on/off switching signals of the main board to IP Extender.
SMART IP EXTENDER
7

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the Smart and is the answer not in the manual?

Subscribe to Our Youtube Channel

Table of Contents