GE ZIC36N RH Manual And Installation Instructions page 33

ZKHCSSI Trim Kit (For 1/4" Panels)
Tubular Stainless Steel Handles
Step 2
Match
handle
extrusions
to handle
See Step 2A
for Stainless
Steel panels
• Cut a piece of corrugated to use as a pad to protect
the panel finish. Use 1/2" thick section of plywood to
protect flooring when drilling.
• Place custom panels on the pad, appearance side
down.
Freshfeed door:
• Onthe back side of the panel - at the handle side,
measure and mark 1/4" below the top edge of the
panel with a pencil.
• Slip panels into new extrusion on the handle side of
the panels.
• Align the extrusion at the pencil mark, 1/4" below the
top of the panel.
• Tape the extrusion to the panel to prevent movement.
• Center punch and drill 1/8" pilot holes through the
holes in the extrusion and into the panel.
• Turn panel over. On the appearance side, use 9/32"bit
to enlarge clearance hole.
Freezer drawer:
• Lay panel on the pad, appearance side down.
• Slip panel into the new extrusion on the handle end.
• The panel should be even with both ends of the
extrusion. Tape panel to extrusion to prevent
movement.
• Center punch and drill 1/8" pilot holes through the
holes in the extrusion and into the panel.
• Turn panel over. On the appearance side, use 9/32"bit
to enlarge clearance hole.
IMPORTANT'. Hole locations must be exact to accept
handle standoff and handle assembly,
Decorator
Door--/
Panel
_Extrusion
I
I
33