GE Monogram ZV1050 Installation Instructions Manual page 3

Design Information
CONTENTS
Design Information
Product Dimensions ......................................................... 3
Duct Cover Accessories .................................................... 3
Product Clearances .......................................................... 3
Advance PImming
Tools and Materials Required .......................................... 4
Power Supply .................................................................... 4
Duct Fittings ...................................................................... 5
Installation Instructions
Step 1, Plan the location,
Ceiling Support Structure ...................................... 6
Ductwork ................................................................. 7
Step 2, Remove Packaging ............................................... 8
Step 3, Check Installation Hardware ............................... 8
Step 4, Mount Template ................................................... 9
Step 5, Install Support Frame .......................................... 9
Step 6, Secm'e Wiring ..................................................... l 0
Step 7, Size and Install Ductwork .................................. 10
Step 8, Install Decorative Duct Covers .......................... l l
Step 9, Install Hood ........................................................ 11
Step l 0, Comaect Electrical ............................................ 12
Step l l, Slide Duct Cover Down .................................... 12
Step 12, Install filters, Finalize Installation ................... 13
PRODUCT DIMENSIONS
This xent hood is designed to be used in x ented ceiling
motmted installations.
_Height
to Ceiling
_ 10"
* 20"to an 8ft. ceiling.
Using supplied duct cover
32" for 9 ft. Ceiling.
Using ZX1059SFSS Accessory
44"for 10ft. Ceiling
Using ZX10510SFSS Accessory
This xent hood is supplied with a decoratix e duct coxer to
reach 8 ft. ceiling height, or bet_xeen 7' 11" and 8' 1".
DUCT COVER ACCESSORIES
Order Accessorv duct covers tor 9 ft. and 10 ft. ceilings.
ZX1059SFSS - For 9 tL ceiling height
This kit includes a decorative duct cover and support
fl'ame to reach a 9 fl ceiling height.
ZX10510SFSS - For 10 ft. ceiling height
This kit includes a decorative duct cover and support
fl'ame to reach a ] 0 fl ceiling height.
Order the accessorv at the same time as the vent hood
and have on site before installation begins.
PRODUCT CLEARANCES
The vent hood must be installed 25-1/2" rain. and 30"
max. above the cooking stlrlhce. 30" is recommended
t()r S t[, ceilings. 30" clearance will insure that the duct
cover meets the ceiling. The cooking smthce should be
at least 36" above the floor. Installation will be easier if
the vent hood is installed betore the cooktop and
cotmtertop is installed.
.... [] .... [
*30"
Recommended
I
36" Min.
I
o
"9 ft. to 10 ft. ceilings may be 25-1/2" to 30" clearance.
*The distance between the cooking surface and the bottom of the
hood must be at least 25-1/2".The 30" recommended installation
height, above the standard 36" countertop, will insure duct cover fit
to the ceiling. For 9ft and 10ft. ceilings, the hood may be lowered to
25-1/2"over the cooking surface.
IMPORTANT: Clearances may vary due to type of cooking product
and local codes. Check with local inspectors to be sure standard is
applicable.
-When installing the Island Hood above a Monogram Professional
Range or Cooktop, installation clearance must be at least 30".
3