GE Monogram ZV1050 Installation Instructions Manual page 12

Installation Instructions
ISTEP101
CONNECT ELECTRICAL
Verify that power is turned off at the source.
WARNING:. ,,.,,se,, iri, g i s n.t>,ire ,,,,
a grotmd wire, a grotmd must be provided bv the
installer. When house wiring is almninmn, be sm'e
to use UL approved anti-oxidant compotmd and
_lh,II/iI_ HIll -t o-copper coi_nectors,
ATTENTION -
le c_iblage de la maison
n'est pas du type h deux ills avec tm fil de terre,
l'installatem" dolt fimr,air t,,a circuit de terre. Quand les
ills de la maison sont en aluminium, il prendre soin
d'utiliser de la pfite antioxidation approuv_e par UL et
des cmmectem's pore" l'aluminium-cuivre.
• Install strain relief onto the knockout of thejm_ction
box cover.
• Insert house wiring through strain relief and tighten.
• Comaect white leads to branch circuit white lead.
• Comaect black leads to branch circuit black lead.
• Comaect green/yellow leads to branch circuit green
or bare grotmd lead.
• Secm'e all comaections with wire nuts on each
electrical coiln ector.
• Push wires into junction box and replace cove,'. Be
sm'e wires are not pinched.
I STEP 111 SLIDE DUCT COVER DOWN
hstaH
Decorative
Screw
• Hold the decorative duct c{we," and remove the
decorative stop screw fl'om the support fl'ame.
Keep the screw.
• Slide the lower duct cover down onto the hood.
• Install the decorative screw in the lower left hole on
the duct cover as shown.
12